To determine the mean elevation of a station O interpolated in a triangulation system, the followingobservations were madeStation Height ofInstrument1.5301.531.53Station Distance Height ofObserved (in m) Signal36845.5846984.114.95028.6DEFVerticalangle+1°1'20"+0°52'50"+0°34′10"RemarksR sin 1" 30.88 mm = 0.07 log sin1°= 6.685575 Find the mean elevation of station O, given that elevation of D, E and F are 293.58, 157.725 and179.335 respectively.

Answered: Image /qna-images/answer/f905fbab-d2a4-4ce7-b0bf-206f292aaa05.jpg

To determine the mean elevation of a station O interpolated in a triangulation system, the following observations were made Station Height of Instrument 1.53 1.53 1.53 0 Station Distance Height of Vertical Observed (in m) Signal angle 3684 5.58 +1°1'20" 4698 4.11 5028.6 4.9 D E F Remarks R sin 1" 30.88 m +0°52'50" m = 0.07 log sin1° = 6.685575 +0°34'10"

To determine the mean elevation of a station O interpolated in a triangulation system, the following observations were made Station Height of Instrument 1.53 1.53 1.53 0 Station Distance Height of Vertical Observed (in m) Signal angle 3684 5.58 +1°1'20" 4698 4.11 5028.6 4.9 D E F Remarks R sin 1" 30.88 m +0°52'50" m = 0.07 log sin1° = 6.685575 +0°34'10"

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Subject: FUNDAMENTALS OF SURVEYING AND MAPPING Please show your solution.
21) Compute the most probable value, standard deviation, and 95% probable error for the following set of angle observations. 116°13'46",116°13'46",116°13'48",11613'44",116'13'50" MPV = 0= E95% =
Problem 1 Based on the following survey data an angle is measured repeatedly using the same equipment and procedure. If the probability of error is 50%, determine (a) the most probable angle and (b) its relative precision; Trials Measurements 1234567 2 4 5 7 162°20'00" 162°21'20" 162°21'40" 162°20'40" 162°19'40" 162°21'25" 162°22'10"
Stadia Tacheometric Survey Problem 3. In the figure, the difference in elevation between observed points A and B is 15 m and the horizontal distance between them is 35 m. With transit at Station O, additional information was obtained as shown in the table. Determine the stadia intervals at A and B. Assume K=100 and C = 0. Occupied O Station Observed A B B RR (m) 1.863 1.500 S ? ? A VCR 12° 10⁰
Jr, a civil engineer was to estimate the height of a transmission tower (G). He performed trigonometric leveling from 3 stations E, Y&A, using slope distances and vertical angles. The survey data are as follows: SEG = 678.56; aEG= 5°30' Syg = 555.31; aye= 3°10' SAG = 900.31; a 46= 2°45' Elevations of stations above the MSL datum HE = 253.31 ft| Hy= 287.64 ft. H= 275.11 ft. Compute the elevation at the top of the cell tower from pt. Y Select the correct response: 412.35 ft 318.32 ft 253.32 ft 320.35 ft
Please assist with this survey question on collimation error
1. A tachometric surveying was performed by a surveyor. The transit used has a stadia interval factor of 90.98 and stadia constant of 0.16m the instrument was set at station O on the line between station C and E. The following stadia readings were taken Position of staff Vertical angle 7-18°37'02" 6°15'58" Station C Station E upper 1.432m 2.825m Stadia hair reading center 1.195m 2.049m Determine the horizontal and vertical distance between C and E lower 0.957m 1.274m
An elevation must be established on a benchmark on an island that is 2536.98 ft from the nearest benchmark on the island’s shore. The surveyor decides to use a total station that has a stated distance measuring accuracy of (3 mm +3 ppm) and a vertical compensator accurate to within 0.4”. The height of instrument was 5.37 ft with an estimated error of 0.05 ft. The prism height was 6.00 ft with an estimated error of 0.02 ft. The single zenith angle is read as The estimated errors in instrument and target centering are 0.003 ft. If the elevation of the occupied benchmark is 632.27 ft, what is the corrected benchmark elevation on the island? (Assume that the instrument does not correct for Earth curvature and refraction.) What is the estimated error in the computed benchmark elevation if the instrument has a DIN 18723 stated accuracy of +-3"?
A horizontal angle é is measured by four different surveyors multiple tunes and the values reported are given below. Angle 36°30' 36°00' 3 35°30′ 4 36°30′ The most probable value of the angle 8 Surveyor 1 Isus 2 Number of observations 4 3 8 4
A level loop was run and the raw elevations in Table 2 were calculated based on backsights and foresights. A plan view of the loop is shown in Figure 2. The true elevation of BM1 is 195.00 ft. Adjust the elevation of each station such that the error is evenly spaced. Show sample calculations of your work. Also determine the accuracy ratio of the survey. BM₁ 5 mi 3 mi BM2 BM4 3 mi BM3 4 mi Figure 2 Table 2 Station Raw Elevation [ft] BM1 195.0 BM2 205.6 BM3 209.8 BM4 204.7 BM1 195.5
Please solve and choose the correct answer in the choices below I'll rate!
surveying errors and mistakes