Estimate the concentration in the river below the confluence. **Problem 1****Context:**Three streams converge to form one river. Flow and pollutant measuring stations are located on the three streams. On a day when simultaneous measurements are made, the mean flow rates and concentrations of a pollutant are as follows:**Data Table:**| Stream | Q (cfs) | C (mg/L) ||--------|---------|----------|| 1 | 26.3 | 127 || 2 | 51.4 | 62 || 3 | 37.8 | 94 |**Task:**Estimate the concentration in the river below the confluence.**Explanation:**The table displays data for three streams, each with its flow rate (Q) measured in cubic feet per second (cfs) and the concentration of a pollutant (C) in milligrams per liter (mg/L). The task is to compute the resulting concentration in the river formed by the convergence of these streams.

Answered: Image /qna-images/answer/212c9a4f-2ed7-4159-a944-f97f62f040a9.jpg

Three streams converge to form one river. Flow and pollutant measuring stations are located on the three streams. On a day when simultaneous measurements are made, the mean flow rates and concentrations of a pollutant are as follows: Stream (cfs) (mg/L) 1 26.3 127 2 51.4 62 37.8 94 Estimate the concentration in the river below the confluence.

Three streams converge to form one river. Flow and pollutant measuring stations are located on the three streams. On a day when simultaneous measurements are made, the mean flow rates and concentrations of a pollutant are as follows: Stream (cfs) (mg/L) 1 26.3 127 2 51.4 62 37.8 94 Estimate the concentration in the river below the confluence.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Engineering fluid … The crest of a high, broad-crested weir has an elevation of 100 m. If the weir is 10 m long and the discharge of water over the weir is 25 m3 ⁄ s, what is the water-surface elevation in the reservoir upstream?
A detention basin with dimensions of width, 20 m, length, 85 m and maximum height, 4 m, receives water from an inflow hydrograph of total volume 14000 m3. The volume of water in it when the water depth is 2.5 m is 4250 m3 O 14000 m3 (the value of the inflow hydrograph) 6800 m3, because the volume of the inflow hydrograph exceeds the maximum volume of the basin O 2550 m3 [= 85 x 20 x (4 - 2.5)]
7. (Mass balance, A river with 400 mg/L of salts (a conservative substance) and an upstream flow of 25.0 m³/s receives an agricultural discharge of 5.0 m³/s carrying 2,000 mg/L of salts. The salts quickly become uniformly distributed in the river. A municipality just downstream withdraws water and mixes it with enough pure water (no salt) from another source to deliver water having no more than 500 mg/L salts to its customers. What should be the flowrate mixture ratio F of pure water to river water?
Three Decimal Places Only
There is a water supply well in an unconfined sand aquifer in Cape Cod near the shore. It has a screened section that extends from 25 to 45 feet below sea level. Without pumping, the water level in the well is 7.0 feet above sea level. The well was pumped at a steady discharge, and by the end of one week the water level was 1.0 foot above sea level. The water pumped during the week was consistently fresh with no significant change in salinity. Density of seawater is 1.025 g/cm3. Density of freshwater is 1.000 g/cm3 a) sketch the problem and estimate the level of the saltwater interface at the location of the well before and after the week of pumping. b) proceed with the calculation as if the conditions related to the Ghyben-Herzberg equation apply. c) Using the equation above, does the problem violate any of the following and if so why: The interface between the fresh and saltwater is sharp with no mixing, There is no resistance to vertical flow in the saltwater or the freshwater…
Describe three of the most prevalent uses of reservoirs in dry regions.
A sedimentation basin in a water treatment plant treats a flow of 4.7 mgd and has the following dimensions: L= 141; W = 23'; Depth of water = 14. Calculate the overflow rate (OR) for the basin (in units of gallons per minute per square foot, gpm/ft?).
At a particular time, the storage in a reach of the Truckee River is 55.3 acre-ft. At that instant, the inflow into the reach is 375 cfs and the outflow is 563 cfs. After 2 hours, the inflow and outflow are 600 cfs and 675 cfs, respectively. (Hint: you will need to estimate the average inflow and outflow rates to complete the problem) • Determine the change in storage volume during the 2 hours. • Determine the stored volume after 2 hours.
2. You're designing a stilling basin and you need to know the minimum length of that basin and also how much energy loss will be achieved before flow is released into the downstream channel. Given the basin width is 10-feet, the flow rate is 240 CFS, the upstream froude number is found from hydraulic modeling to be 4.0. Solve the following: • Minimum length of the stilling basin. • Energy loss within the stilling basin (Calculate both energy loss in feet and in tons). • The depth of water being released outside of the stilling basin. • The Froude Number being released from the Stilling Basin. • Look at USBR Design of Small Dams and Write a paragraph (4-5 sentences) of the recommended stilling basin you would propose for the hydraulic scenario.
Question 16 1 points Save A A triangular trough is 5 m long, 2 m wide at the top and 2 m deep. If industrial strength acid is flowing at a rate of 4.8 m-/min, how fast is the area of the surface of the liquid increasing in m2/min when the acid is 101 cm deep? Express your answer in 2 decimal places.