Three forces, each of magnitude P= 4 kN, are applied to the structure shown. Determine the cross-sectional area of the uniform portion of rod BE for which the normal stress in that portion is +100 MPa. 0.100 m IP IP 600 0.150 m 0.300 m 0.250 m The cross-sectional area of the uniform portion of rod BE is| |mm2.

Q: 2. For the bone shown to the left, assume the cross-section at C can be approximated as annular,…

A: Given:Average normal stress, σ=3.8 MPaLoad applied, P=1200 Nouter diameter, d=25 mm

Q: The steel bracket is used to connect the ends of two cables. Y Part A O max = If the applied force P…

A: P=d=To determine:The maximum normal stress

Q: Two solid cylindrical rods (1) and (2) are joined together at flange B and loaded as shown. If F₁ =…

A: Given data: Load acting , F1 = 15 kips   and F2 = 34 kips Normal stress has to be limited to 17 ksi.…

Q: f F1 = 1070 lb and F2 = 2095 lb, determine the magnitude of the normal stress produced at point H.…

A: Given that ,  F1=1070lbF2=2095lb

Q: 2.17 In using this leg curl machine the exertion of the legs results in a torque M 120 lb-ft on the…

A:

Q: If F1 = 1070 Ib and F2 = 2095 Ib, determine the magnitude of the normal stress produced at point H.…

A: Given: The force, F1 = 1070 lb The force, F2 = 2095 lb

Q: 2. Determine the maximum force P that can be exerted on each of the two pistons so that the…

A: Given: The radius of the piston is R=45 mm. The wall thickness is t=2 mm. The circumferential stress…

Q: Three forces, each of magnitude P = 3 kN, are applied to the structure shown. Determine the…

A: Solution.jpg

Q: The state of stress at a point in a member is shown on the rectangular stress element where the…

A: The state of stress at a point in a member is shown on the rectangular stress element where the…

Q: Two portions of member AB are glued together along a plane forming an angle with the horizontal. The…

A:

Q: Draw Mohr's circle that describes each of the following states of stress.

A: Given data:- σx =-8 ksi σy =12 ksi τxv=-6 ksi To draw:- Mohrs circle

Q: B The two rods AB and AC have diameters of 10 millimeters and 8 millimeters. Determine largest…

A:

Combined Loading

Any functioning component, such as machine parts, structural members, pressure vessels, and so on, are all under the influence of more than one force. When anybody is under the influence of more than one force such as shear forces, bending moments, axial forces, torsion, and so on, then such body is said to be under combined loading. A very practical example of combined loading is the crankshaft of an internal combustion engine (IC engine). The crankshaft of the IC engine is under high rpm, which is caused due to the torsional forces. Due to the presence of piston, counterbalances, and internal imbalances, the crankshaft experiences lateral forces and due to the rise in temperature, the crankshaft undergoes thermal expansion, which pulls the crankshaft along the axial direction and lateral direction. The presence of unbalanced loads along the periphery of the crankshaft also induces a bending moment.