Three conductors of a 3-phase overhead line are arranged in a horizontal plane 6 m apart. The diameter of each conductor is 1·24 cm. Find the capacitance of each conductor to neutral per 100 km of the line.  [0·785 μF]

Q: Problem 5 Find the equivalent inductance Leg for the network shown below. 72 mH oooo Leq 49 mH elle…

A:

Q: The ACSR conductor Falcon is used in a 3-phase equidistant configuration with D = 25 feet. The per…

A: Given data : distance D=25 feet

Q: Given a single phase inductance Lm.1) ,1phase = 12 mH, what is the mutual inductance between stator…

A: Given:Single phase inductance Lm,1 phase=12 mH

Q: Impedance of AC circuit and Admittance of AC circuit SHOW THE CIRCUIT USING ANY SOFTWARE OR YOU CAN…

A:

Q: For 3-phase unsymmetrical spacing shown in figure (the diameter is I cm).: Find the capacitance per…

A: Given, For 3-phase unsymmetrical spacing shown in figure,

Q: 7. A steady state of 20 mA is passed through a coil with an inductance of 100 mH. What is the…

A: This question is conceptual and can be answer without solving.

Q: Each of the conductor in a parallel-plate capacitor is called a. dielectric b. insulator c. plates…

A: Parallel Plate capacitors:- It is an arrangement of two conducting plates of equal dimensions are…

Q: Three identical capacitors of 15 micro farad are connected in delta across a 435 volts, 50Hz, 3-…

A: Given Data: C=15μFV=435Vf=50Hz

Q: citor is 3,2 micro voltage of the ge -. Frequency 100 Hz (b) what is the rr it when it is 100C

A:

Q: Increasing the capacitance of an AC circuit causes the capacitive reactance to: a) decrease. Ob)…

A: We need to select correct option for reactance .

Q: Prove that, neutral capacitance is twice of line to line capacitance

A: The capacitance between one of the conductors and a neutral point is known as neutral capacitance or…

Q: Find the mutual inductance between an infinitely long wire and a rectangular wire with dimensions…

A: Suppose current in wire is I and Given diagram is –

Q: When two identical parallel wires are 3 m apart, the inductance per unit length is 2.5 μH/m.…

A:

Q: In the experiment set-up, what is the Inductance in the given AC supply 9.364 mA R=1500 L=? 40HZ…

A: we need to find out value of L.

Q: Sinusoidal voltage (or emf) is generated by rotating a conductor by means of a spindle in a uniform

A: In this question we need to complete the given statement .

Q: Two series resistors are connected to an AC source. If there is 6.5 V(rms) across one resistor and…

A: Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: Find the inductance in mH/km of the follo

A:

Q: In capacitive AC circuit voltage is leading current O a. True O b. False

A: In the given questions we need to discuss about the properties of capacitor.

Q: 2 The conductors in a single phase ine are 6m above the guünd. Each conductors are spaced 3m a pant.…

A:

Q: A. For the following figure, the diameter of each conductor is 2.5 cm. Find the inductance and…

A:

Q: A 1 kV, 50 Hz underground cable has a capacitance of 0.38 µF/km per/phase. How much reactive power…

A:

Q: If the area of cross-section increases, the resistance of the conductor decreases. Select one: O…

A:

Q: The ACSR conductor Falcon is used in a 3-phase equidistant configuration with D = 42 feet. The per…

A: Given data, D=42 feet Standard data, For Falcon ACSR(steel) Diameter=0.5150 inch

Q: When two identical parallel wires are 3 m apart, the inductance per unit length is 2.5 μH/m.…

A:

Q: How many degrees are the current and voltage out of phase with each other in a pure inductive…

A: Total impedance offered by a purely inductive circuit is purely imaginary which means the real part…

Q: A transmission line of 50 Q characteristic impedance is terminated with a 100 Q resistance. Find the…

A: Given, Characteristic impedance Zo = 50 ohm Load impedance ZL = 100ohm We need to determine the…

Q: Two identical air core solenoid has 200 turns, length of 25 cm and cross-sectional area of 3 sq.cm.…

A:

Q: When a resistor is connected across the terminals of an ac generator (117 V) that has a fixed…

A: The generator voltage and current when only resistor was connected to the generator,When the…

Q: The capacitance of one conductor with respect to the neutral plane is times the capacitance of the…

A: Correct option is two The capacitance of one conductor with respect to the neutral plane is two…

Q: Three identical capacitors of 10 micro farad are connected in delta across a 415 volts, 50HZ,…

A:

Q: The capacitance between the two conductor is 255 Farad per meter, then the Capacitance between line…

A: Given, The capacitance between the two conductor is 255 F/m. Note :- The capacitance between the…

Q: The series capacitance causes real power loss in the conductor. Select one: O True O False

A: Capacitor is can supply leading VAR to the line and does not consume any real or active power in the…

Q: Calculate the inductance of the single-phase double circuit line shown in the figure, the diameter…

A:

Compensation Techniques

The compensation techniques are the methods that are employed in the electrical control systems to enhance the performance of the system. The performance are generally affected by the factors like lag in the compensating devices, slow response of the system of the components like sensors used in the control system. The basic compensation technique involves lag compensation, lead compensation or the combination of the both.