1. What is the relationship of voltage and current (concerning phase angle) in a pure resistive circuit? 2. What is the relationship of voltage and current (concerning phase angle) in a pure inductive circuit? 3. What is power factor?

Q: Determine the differential equation that define the loop connected to the voltage source.

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source,…

Q: please write the solution on paper.

A: In this question we need to find a inductance and phase angle between the current and the source…

Q: (Note that the a,b,c,d are branches) 1. Measure and record the potential difference for the…

A: Nodal analysis is a technique used to calculate currents in each path using KCL. KCL states that the…

Q: The resitance of a wire is 25 ohms at 50°C and 20 ohms at 30°C. Determine the temperature…

A: Resistance is defined as the opposition of current flow and it depends on the type of material…

Q: Q3: For the network shown in figure (3), if the switch is closed for 2usec and then opened for…

A: Given circuit is  Let assume switch was open for time t<0 sec Case-I: 0<t≤2 μs switch closed…

Q: Explain the basic concepts of direct current and alternating current, and the main applications that…

A: We have to explain the basic concepts of direct current and alternating current, and the main…

Q: 180 V Ф - 50 ms

A:

Q: a. An AC RLC circuit is shown in FIGURE Q2a. 220 mH 36 V 25 Q 50 Hz 70 µF FIGURE Q2a i. Determine…

A:

Q: What is dimensional formula of conductivity ,it's unit and answer in well manner step wise and also…

A: The dimensional formula for conductivity is derived as given below, P=i2R P=i2ρlA On rearranging,…

Q: 1. The inductance of a single layer solenoid is 5 mH. Find the value of inductance when the number…

A: We need to find out inductance for given number of turn and length

Q: A series circuit consisting of 10 ohm resistance and 60 mH inductance is connected to a 220-volt,…

A:

Q: Which of the following statements about the electrical characteristics of biopotential electrodes is…

A: A biopotential electrodes is a transducer shich is used for producing electric current by sensing…

Q: Q2) Non – sinusoidal voltage applied on 102 resistance with consumed power 521.25 watts and the…

A: We need to find out current and effective voltage for given power .

Q: Faraday and Henry are the units for inductance and capacitance. Select one: True False

A: In this question , we will write units of inductance and capacitance .

Q: . This is the rate at which current changes direction per second. * A. Capacitance B. Charge C.…

A:

Q: A tungsten filament bulb rated at 500 W, 100V is to be connected to a series with a capacitance…

A:

Q: A sinusoidal voltage has a peak value of 340 V. Calculate its mean and r.m.s. values, correct to 3…

A: Given information is shown below:

Q: A resistor and an inductor is connected in series across an AC supply. In this circuit, the current…

A: In circuit resistor R and inductor L is connected in series. So this circuit is RL circuit. So…

Q: Question/s 1) Solve the following values in figure 1.0. a) Total Capacitance, Ct. b) Total Charge,…

A: If capacitors C1 , C2 , C3 are connected in parallel than equivalant capacitance is C1 +C2+C3.…

Q: A) The apparent power for an electric network was measured and found to be 360.6VAL- 56.34. 1.…

A: Hello. since you have posted multiple questions and not specified which question to solve. We will…

Q: A resistor of 5 ohms is connected in parallel with an inductive reactance of 10 ohms, then connected…

A:

Q: 5 sinir s A thyristor is used to control the voltage to load resistance from 220 V, 50 Hz single…

A: Given- A thyristor- 220 V, 50 Hz single phase ac supply- diadt rating of 50 A/μs, To Find- The…

Q: Electrical Engineering What are the implications of intensity in energy generation

A: Given: Energy intensity: Intensity has a deep role in the energy generation. Energy intensity is…

Q: Question- A solar cell of 350 V is feeding power to an ac supply of 440 V, 50 Hz through a 3-phase…

A: Given- Solar cell of 350 V, E=350 V, 440 V, 50 Hz supply, Current I=20 A, Resistance R=0.5 ohm, To…

Q: A current of - 8 + 62-V (sin (wt + 30°)) A is passed through three meters. The respective readings…

A:

Q: In the figure on the right, the ideal batteries have emfs &1= 10 V and 82 = 83 = 6 V and the…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: Determine ZT for the circuit if inductive reactive is 10220 and resistance is 9850. Answer:

A: Given: A circuit is having Inductive reactance, XL=1022 Ω Resistance, R=985 Ω

Q: hy do computed actual inductance still the same even though freqquencies are different? explain why.

A: Inductance of any wire  is dependent on the material of the of the wire and it's property it is…

Q: A capacitance is rated 100 kVar, 380 volts, 50 hz. What will its rating be at 60 Hz 220 V?

A: This question belongs to circuit theory . It is based on the concept of calculation of rating of…

Q: A supply of 250 V, 80 Hz is connected across an inductive load and the power consumed is 2 kW, when…

A:

Q: Inductors of 1 H and 2 H are connected in series to a 440-V, 60-Hz power supply. Determine the…

A:

Q: 12. A resistance, inductance and a capacitance of 120uF are connected in series. When the voltage…

A:

Q: The equation of two currents in parallel connected in electric devices are i = 12 sin ( 377t +T/4)…

A: Two equation of currents are given  Both current in parallel connected in electric devices  Find the…

Z parameter

The Z-parameters that are the impedance parameters of a two-port network are defined by expressing the two-port voltages V1 and V2 in terms of two-port currents I1 and I2. The Z-parameters are calculated by open circuiting one of the two ports at a time henceforth they are called open-circuit impedance parameters.