Three client channels, one with a bits of 200 Kbps, 400 Kbps and 800 Kt ps are to be multiplexed a) Explain how the multiplexing scheme will reconcile these three disparate rates, and what will be the reconciled transfer rate. b) Use a diagram to show your solutions

Q: . What is the main feature of Time Division Multiplexing? a. simple and easy to implement b. fair…

A: Synchronous TDM does not require identity bits to be included in a message since the receiving…

Q: the difference between QPSK and offset QPSK? 2) Five channels, each with a l00 kHz bandwidth, are to…

A: 1. the difference between QPSK and offset QPSK 2.Five channels, each with a l00 kHz bandwidth, are…

Q: A path in a digital circuit-switched network has a data rate of 1 Mbps. The exchange of 1000 bits is…

A: Here, we have to write solutions for the above questions.

Q: Two channels one with a bit rate of 190Kbps and another with a bit rate of 180 Kbps are to be…

A: The Answer is

Q: A 20 Kbps satellite link has a propagation delay of 400 ms. The transmitter employs the "go back n…

A: Introduction :Given , Implementation of "go back n "link bandwidth = 20 Kbps Tp = 400 ns n= 10 Frame…

Q: How long does the asynchronous transmission of a 150 KByte (1 KByte = 1024 bytes) file take via a…

A: Solution:--   1)The given question has required for the solution which is to be provided as the…

Q: Ten signals, each requiring 3000 hz, are multiplexed onto a single channel using FDM. How much…

A: Here in this question question we have given Ten signals, each requiring 3000 hz.we are using FDM…

Q: A TDM link has line rate of 1.536 Mbps. If an individual session requires 64 kbps, how many…

A: The purpose of this calculation is to determine the number of simultaneous sessions that can be…

Q: The data rate (in each direction) necessary for a digitized telephone call is 8 Kbps. This means…

A: Given, A full duplex call requires 16 kbps data rate. Data rate necessary to transport just one HDTV…

Q: Consider the CDMA technique and assume that users A and B have spreading codes 01010101 and…

A: Multiple users can concurrently share the same frequency band thanks to a digital cellular…

Q: The error and flow management in synchronous time-division multiplexing is achieved by use of data…

A: TDM is a technique for sending and receiving separate signals across a shared signal route using…

Q: a. Assume your university library has a million books. Calculate the number of bytes of data if all…

A: a. With regards to the aforementioned issue, it has previously been stated that the campus library…

Q: Assume two hosts, A and B, that are linked by a single link with a rate of R bps and are spaced m…

A: Sure, let's break down the questions step by step and calculate the values.Rate of the link (R) = R…

Q: what the total time required to send 5000 bytes across a 3000 kilometers link at 1 Mbps?use a signal…

A: The transmission time (Tt) = L/B  = Length of the data / Bandwidth   The propagation time (Tp) = d /…

Q: Assume that a voice channel occupies a bandwidth of 4 kHz We need to combine four voice channels…

A: FDM means frequency domain modulating in this technique multiple signals are combined on a single…

Q: For the following stream of digital signal which is being transmitted by bit rate 5 Kbps:…

A: a. Draw waveform for all line code is self synchronized or not.

Q: Can I have a detailed, step-by-step explanation for the following question? Thank you very much!…

A: We have 4 channels that are multiplexed using TDM. If each channel sends 100 bytes/second and we…

Q: Problem 1. We want to design a communications link with 8 PSK waveform. The channel BW is at most 80…

A: We want to design a communications link with 8 PSK waveform. The channel BW is at most 80 MHz and…

Q: ive three examples of when multiplexing is used. How does Statistical-TDM deal with bandwidth waste…

A: Introduction: Multiplexing is a method of merging many analog or digital signals into a single…

Q: A serial transmission T1 uses 8 information bits, 2 start bits, 1 stop bit and 1 parity bit for each…

A: Introduction  serial transmission T1 info bits 8 Start bit 2  Stop bot 1  Parity bit 1 synchronous…

Q: III. The figure below shows synchronous TDM, the data rate for each input connection is 1 Mbps. If 1…

A: ans given below

Q: SAMPLE DATA HELLO CODE

A: A)in below figure shows how to transit message  are multiplexed into frames.

Q: Two channels one with a bit rate of 190Kbps and another with a bit rate of 180 Kbps are to be…

A: Given: Two channels:  1) One with a bit rate of 190Kbps. 2) Another with a bit rate of 180 Kbps.…

Q: 13. Suppose a 1-Gbps point-to-point link is being set up between th Earth and a new lunar colony.…

A:

Q: Figure 4 illustrates the relationship between bit-error-rate (BER) and E/No in a wireless…

A:

Q: 2. (a) Suppose a radio channel occupies a bandwidth of 11 kHz. We need to multiplex 14 radio…

A: As required, I'm providing both answers with all subparts. I hope this will be helpful for you...

Q: Computer Science assume a frame is traveling from Station A to Station B. The switches have been…

A: Actually, LAN is a Local Area Network.

Q: Two channels one with a bit rate of 190Kbps and another with a bit rate of 180 Kbps are to be…

A: The answer is

Q: Consider a channel with spectrum from 3 to 7MHHZ and SNR(dB) = 20dB. What is the maximum theoretical…

A: Channel is noisy as SNR( Signal to Noise Ratio ) is given. Maximum theoretical data (C) is given by:…

Q: Suppose a 128-kbps point-to-point link is set up between the Earth and a rover on Mars. The distance…

A:

Q: MIMO and frame aggregation are techniques used in recent Wi-Fi standards for increasing capacity.…

A: A wireless access point is an essential component of a Wi-Fi ad-hoc network.(TRUE) Because the…

Q: Design a statistical multiplexer. Traffic parameters: arrival rate = 1,000 packets/sec & average…

A: Solution:   Given,

Q: Calculate the latency (from first bit sent to last bit received) for the following: (a) 100-Mbps…

A: On a 100 Mops network, each bit takes 1/108 = 10 ns to transmit. One packet consistsof 12000 bits,…

Q: iv) The accepts the multiplexed data stream, separates the data according to channel, and delivers…

A: Ans iv) D:  demultiplexerExplanation- The demultiplexer accepts the multiplexed data stream it…