thread the outer Jiem 10

Q: Distinguish nominal diameter and gross diameter of bolt

A: Nominal diameter:Nominal diamater can be described as the pitch diameter of the thread of the…

Q: Problem 6 You've been asked to design a stamping tool as shown. What are the internal forces at A…

A: FBD

Q: 8-5 lem 8-5 The machine shown in the figure can be used for a tension test but not for a compression…

A:

Q: If the pitch of a thread is 1/18 inch, how many threads are needed for the threaded section of a…

A:

Q: The thread depth is  measured along the ----------------- of the thread. Pitch Crest Angles Face

A: Thread: A thread is a simple machine structure mainly used to convert the the linear motion of force…

Q: I need the answers to this question.

A: The explanation of the above terms have been explained below.

Q: True and False questions 1 The teeth of the helical gears are cut parallel to the shaft axis. 2. All…

A: Since you have posted a question with multiple sub-parts, we will solve first three sub- parts for…

Q: What is the angle theta If D is 0.508?

A: Given DataThe taper per ft is; 0.500/ftThe tape length is;

Q: Write the thread notes for the following internal threads. Do only (b), (e) and (g). Also, what are…

A: Given data,   a b c d e f g Majorϕ 716 14 58 114 38 12 1 Series fine coarse fine coarse  fine…

Q: Compute for the desired degrees to set in the compound rest to taper a plum bob with 4.8 large…

A: Large diameter, D= 4.8 Length of the taper, L= 9.6 Small diameter is not given. Hence, take small…

Q: Q1: Power square thread lift 10 tons, dm= 40 mm, do= 46 mm & u=0.15 . choose the thread angle (2)…

A:

Q: For an internal thread, If the 3.75mm pitch and Tap drill size is 12 mm. Find the Nominal diameter.…

A: pitch=3.75 mm  tap drill size =12mm nominal diameter =?

Metrology of Screw Threads

Screw threads are a series of ridges having the profile of a helix. This helix profile runs continuously along the length of a uniform solid or a hollow bar of a circular cross-section at periodic intervals. These helix ridges are also formed over a conical bar. These continuous helical ridges are termed threads.