This wood flume has a slope of 0.0015. What will be the discharge of water in it for a depth of 1 m? Try to use all the open channel formulas and make the necessary assumptions for the roughness coefficients.

Q: According to the information given in the table, draw the project (in a circle) and indicate it with…

A: Dotted line represents Dummy network.

Q: Write the ten main divisions of The Federal Highway Administration Standard Specifications?

A: The Federal Highway Administration (FHWA) is a division of the United States Department of…

Q: wHAT DOES THE CPM do?

A:

Q: How is the inspection plan developed?

A: - Inspection plan is developed to provide information on the testing characteristics to ensure the…

Q: Please make a PERT CPM use the activity and duration below. Also use the format stated. PLEASE DON'T…

A: I will create a PERT CPM (Program Evaluation Review Technique Critical Path Method) chart using the…

Q: The three basic stages of construction planning are: (A) Preconstruction planning, post-construction…

A: Three basic stage of construction planning are: Pre conceptual planning Conceptual planning  Post…

Q: For the following network all times are in days. Activity Duration Predecessor 5 10 A B 15 10 A A D…

A:

Q: meant by the term triage?

A: It is a general term it means when doctor receive two or more patients with different degree of…

Q: What is an RFI and how is it used?

A: The RFI is an abbreviation of Request for Information, it is a standard process whose purpose is for…

Q: Do not include the unit in writing the answer. Use small letters (lowercase) in writing the words…

A: Calculate area as follows:

Q: Please give proctor test results and graph.

A: Proctor test  A geotechnical laboratory test process known as the Proctor compaction test is used to…

Q: Determine the Departure Misclosure and Latitude Misclosure for the four sided parcel shown below.…

A:

Q: Define the term vadose zone.

A: Vadose zone is defined as the zone which lies between the water table and top of the ground surface.

Quantity takeoff

Quantity takeoffs (QTO) are precise estimates of the materials and labor costs required to finish a construction project. During the pre-construction phase, an estimator prepares them, breaking down the project into smaller, more manageable parts that are easier to evaluate. These measurements are used to prepare a construction scope bid. Estimators examine the drawings, specifications, and models to figure out different quantities and their costs. Since, the components, their quantity, and price are all included in the model, quantity take-off can be done automatically using Building Information Modelling (BIM). The time taken for completing a construction project can be reduced by the use of quantity takeoff. These takeoffs are also called material takeoffs and construction takeoffs.