This is the first part of a three-partquestion. Water at the inlet to the pumphas pressure of 100 kPa andtemperature of 15°C. What is thespecific enthalpy (h) of the water at theinlet to the pump?21+ This is the second part of a three-partquestion.A ¼ hp pump is used to pump water.What is the absolute value of themaximum power input to the pump? [1hp = 0.73549 kW]:-1

Answered: Image /qna-images/answer/cc634912-90d6-4427-99da-b639940f4977.jpg

This is the first part of a three-part question. Water at the inlet to the pump has pressure of 100 kPa and temperature of 15°C. What is the specific enthalpy (h) of the water at the inlet to the pump?

This is the first part of a three-part question. Water at the inlet to the pump has pressure of 100 kPa and temperature of 15°C. What is the specific enthalpy (h) of the water at the inlet to the pump?

Refrigeration and Air Conditioning Technology (MindTap Course List)

8th Edition

ISBN:9781305578296

Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Publisher:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Chapter40: Typical Operating Conditions

Section: Chapter Questions

Problem 3RQ: The evaporator will normally operate at a(n) _____F boiling temperature when the indoor temperature...

See similar textbooks

Related questions

Q: -35%- The pressure in the automobile tire depends on the air in the tire. When the air temperature…

A: Given:T1=25°C =298 KPg1=210 kPaV=0.025 m3T2=50°C =323 KPatm=95 kPa

Q: Determine the approximate enthalpy of water at 90 degree celsius.

Q: A compressor takes in refrigerant R-134a at a pressure of 23.8 psia andcompresses it to 122.8 psia.…

A: Given Data⇒ Refrigerant R-134 a Suction pressure Psuction=23.8 PSia Discharge pressure…

Q: If the initial volume of the gas is compressed to one-half its original volume and the new…

Q: An air compressor has a pressure of 150 psia and the surrounding environment is at 15 psia. What is…

A: Given data, P= 150 psia. Pa= surrounding pressure= 15 psia.

Q: A bicycle pump contains air at STP. As the tire is pumped up, the volume of air decreases by 57…

A: STP is 373 K and 1 atm

Q: In a heat engine, water vapor flows into a turbine and then it enters a condenser for rejecting…

A: Given data: Gauge Pressure of steam at turbine inlet, P1=1400 kPa Steam after exiting turbine enters…

Q: Please indicate the given. Determine the optimal intermediate pressures and work needed per kilogram…

Q: What is the original mass and pressure if the original temperature was 315 K. A 5-m^3 tank contains…

Q: A large room contains a volume of air of Va = 11 m3 at a temperature of Ta = 55° F. It also contains…

A: *As per our guidelines we are supposed to answer first three sub-parts of the question. Kindly…

Q: Question # 3 - Water of 2 kg fills a part of the chamber with P = 300 kPa. The other part of the…

A: Given data Mass = 2 kg Pressure p1= 300 kpa Total chamber volume = 1.5 m^3 Initial volume of water =…

Q: A condenser vacuum gauge reads 705 mmHG when the barometer stands at 746 mmHG. State the absolute…

Q: By superheating the stream to a high temperature, the average steam temperature during heat…

A: To check: Whether the given statement is True of false. Explanation: Super heating the steam to…

Q: vessel contains 10 kg of water at 10 x 1 kPa (if last digit is 2 then 10 x 2 = 20 kPa). Determine…

Q: he piston/cylinder device contains 0.4kgof water at a temperature of 1800C and pressure of 0.8 MPa.…

A: Given:Mass of water, m=0.4 kgInitial temperature of water, T1=180°CInitial pressure of pressure,…

Q: Identify the state of the fluid: R134a at 400kPa, with a specific volume of 0.0223m3/kg

Q: Methanol (SG=0.792) is contained in a large tank under a pressure of 350000 Pa absolute. When a…

Q: Predict the changes of the differential height in the manometer if a fluid with the density lower…

Q: 4. A vessel of volume 0.2 m3 contains Nitrogen at 1,013 KPa and 15° C. If 0.2 kg Nitrogen is now…

A: Given:volume of nitrogen, v=0.2 m3Pressure=1013 kPaTemperature=15o Cmass=0.2 kg

Q: A closed vessel contains air at a pressure of 160 kPa gauge and temperature of 30°C. The air is…

A: Given, Initial gauge pressure of air, P1,g=160 kPa The initial temperature of the air, T1=30…

Q: A rigid vessel of volume 0.5m 3 (Vessel X) containing hydrogen at 200K and a pressure of 60kPa is…

Q: A steam turbine carrying a full load of 46 MW uses 77.7 kg/s of steam. The turbine efficiency is…

A: Given: Turbine load = 46 MW ms = 77.7 kg/s of steam turbine efficiency=78% exhausts steam = 26 mm…

Q: A rigid tank contains superheated water vapour at 300 kPa. When the tank is cooled, the superheated…

A: Given that: Superheated water vapor is initially at P = 300 kPa. Water is cooled until it becomes…

Q: Note: 1 Torr 0.133 kPa & 1 atm = 101.325 kPa ) A spray metal bottle is used for polishing some…

Q: What is the absolute pressure in the closed chamber B in Pa.? Mercury S.G= 13.54, Oil S.G = 0.9,

Q: Determine the internal energy of saturated liquid water at 225 kPa.

A: Given data: Saturated liquid water at 225 kPa

Q: An air bubble rises from the bottom of the well where the temperature is 20°C to the surface where…

A: Given data:

Q: If some heat is transferred to the gas and its volume is doubled, do you expect the pressure inside…

A: If the volume is doubled then the pressure inside the gas will not change.

Q: P = 13 Mpa, h= 3191.3 kJ/kg-K T= 320°C, u= 2000 kJ/kg-K d) е) f) P = 1.42 Mpa, T=355 °C

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

What is the difference in the saturated vapor pressure for refrigerant R-134aat the two given temperatures?
Steam enters the turbine at a pressure of 10 bar (absolute pressure) and a temperature of 600oC. Slightly leaving turbine at 1 atm pressure and 90% purity. Looking for the breath to give turbine to it born 1.5 106 kW of work
Switching the temperature for the steam table (c) to be 160 C and the pressure to be 5000kpa (it was a error)
thermodynamics
Please show complete solution.
Determine the type of steam, given: Temperature: 156°C Internal Energy: 1550 kJ/kg O Wet Vapor O Saturated Liquid O Saturated Vapor
calculate T and spesific enthalpy
(4) all öf th (b) dry saturated liquid refrigerant The refrigerant supplied to a compressor must be (a) superheated vapour refrigerant (c) a mixture of liquid and vapour refrigerant (d) none of these ant compressor is called
Q1: Steum at a pressure of 28kpa is passed into a condenser and it leawes as condensate at a temperature of sac Cooling water circulates through the condenser at the rate of 45 kg/min - It enters at 152 and Veaves at 3oc If the Steam flow rate is 1.25 eg/min, determinė the drynes fraction of Steam as it enters the condenser.
What is the ideal mass flow rate for a refrigeration and cryogenic plant for oxygen production? Show solution if necessary and reference.
300 kPa pressure and 20 oC water flowing with a mass flow rate of 2 kg / s,300 kPa pressure and 300 oC mixed with superheated steam during mixing. if it comes out at 65 oC temperature from the mixing chamber;a. Draw the system schematically and examine it.b. Determine the initial mass flow rate of the superheated steam.
Answer the problem correctly and provide complete and readable solutions. If you can explain the process (briefly), please do so. Thank you!