There are two paths in the network shown below: The cost functions are given as: • T₁ = 8 +0.4X₁ • T₂ = 16+0.9X₂ Path 1 Path 2 Assume 5 vehicles travelling between points 1 and 2. Determine the UE flow on path 2. Report your answer correct to 2 decimal digits. Answer:

There are two paths in the network shown below: The cost functions are given as: • T₁ = 8 +0.4X₁ • T₂ = 16+0.9X₂ Path 1 Path 2 Assume 5 vehicles travelling between points 1 and 2. Determine the UE flow on path 2. Report your answer correct to 2 decimal digits. Answer:

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

It is known that 5,000 automobile trips are generated in a large residential area from 3:00 PM to 4:00 PM on Sundays for shopping purposes. If a logit model is estimated with coefficients of 0.0165 for commercial space (in thousands of ft²) and -0.5435 for distance (in miles), how many trips will be made to each of the 3 shopping centers with characteristics shown in the table below? Shopping Center 1 2 3 Distance from Commercial residential area (miles) floor space (ft²) 2.43 200,000 4.67 5.02 150,000 300,000
A toll bridge carries 6000 vch/day The current toll is $3.50/vehicle. Studies have shown hat for each increase in toll of 50 cents, the traffic volume will decrease by 500 veh/day. Jus desired to increase the toll to a point where revenue will be maximized. (a) Write the expression for travel demand on the bridge, related to toll increase and current volume. (b) Determine the toll charge to maximize revenbes. (o Determine traffic in vel/day after the loll increase, (d) Determine the total revente increase with the new tol.
Question. 2Propagation speed of 45 km/hr and that each toll booth takes 6 seconds to service a car.Suppose the caravan of 10 cars begins immediately in front of the first toll booth, travels 20 km to a second toll booth, then another 40 km to a third toll booth, and finally stops immediately after the third tool booth. Thus, they travel a total of 60 km. What is the total end to-end delay?
Assume student arrivals to a check-out counter with a single server are Poisson distributed and have an average rate of 7 people/min. If it takes a constant 3 seconds to serve each of them, what is the average queue length? (please answer with 3 decimal places)
A zone has been divided into four large districts (traffic zones). The following data has been collected for those districts. Provide a trip distribution calculation (single constrained) using the gravity model. Assume Kij = 1 (Check balancing of Tij = A after the first iteration) District 1 2 3 4 Travel Time Fij Productions 3400 6150 3900 2800 1 2.0 Attractions 2800 6500 2550 4400 4 1.6 6 1.0 1 4 11 15 10 9 10 0.9 0.86 Travel time (min) 2 3 11 15 6 6 6 6 9 11 11 12 0.82 0.80 4 10 9 11 4 15 20 0.68 0.49
Two routes connect an origin and destination with performance function t; = aj + (xj/cj)2 (with t's in minutes and x's in thousands of vehicles per hour). It is known that at user equilibrium, 65% of the origin-destination demand takes route 1. How many vehicles (in thousands) will take route 1 if system optimal equilibrium is archived? Route 1 Route 2 a 7 2 3
Please answer in detailed no. 2
10. Queuing models are derived from underlying assumptions regarding arrival patterns, departure characteristics, and queue disciplines. A. True B. False 11. If the service rate is greater than the arrival rate, the delay predicted by D/D/1 can be greater than that predicted by M/D/1: Α. True B. False 12. To apply the equations for M/M/N queues, the ratio of arrival to service rates must be less than 1.0: Α. True B. False
Note: I need right answer with clear calculations . Don't copy from other expert solution.
How do you define D in each part of the solution? Please explain also how do you find the maximun flow rate in each part of the soliution stated above did you use a chart if so please include Maximum service flow rate 1444 pc/hr/ln Maximum service flow rate 1338 pc/hr/ln
A two-lane, one-way, rural freeway segment is being designed to service a demand volume of 4,000 vehicles per hour. The PHF is expected to be 0.95. If the combination of trucks, buses, and recreational vehicles is represented by a heavy vehicle adjustment of 0.85, what is the flow rate (pcphpl)? Provide your answer to the nearest integer.
The utility functions for auto (A), light rail (L), bus (B) and bus rapid transit (BRT) are as follows: U(A) =1-0.00142C-0.025T (C = 6; T = 40) U(L) = 5-0.00142C-0.125T-0.354W (C=1.75, T=25, W=15) U(B) = 16-0.00142C-0.0167T-0.354W (C=1.25, C=60, W=30) U(BRT) = 6-0.00142C-0.0167T-0.354W (C=1.75, C=30, W=15) where C = cost ($), T = travel time in minutes, and W = wait time in minutes Using the logit model, determine the percent of travel by bus rapid transit.