Theory 1. In the space below, state Archimedes' Principle and define density, then show mathematically how you can measure the density of an object WITHOUT knowing its volume. Your answer should be in terms of measured quantities mentioned in the procedure the buoyant force mass mB in a fluid, the mass of the object mob,not submerged, as well as the density of fluid the mass was submerged into. Specifically what is the electronic scale measuring in step 4 above? Be sure to draw a free-body diagram of the system explaining your answer. mob Answer: Pob = Pf' mB

Theory 1. In the space below, state Archimedes' Principle and define density, then show mathematically how you can measure the density of an object WITHOUT knowing its volume. Your answer should be in terms of measured quantities mentioned in the procedure the buoyant force mass mB in a fluid, the mass of the object mob,not submerged, as well as the density of fluid the mass was submerged into. Specifically what is the electronic scale measuring in step 4 above? Be sure to draw a free-body diagram of the system explaining your answer. mob Answer: Pob = Pf' mB

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

Solve the following problems. Show your complete solution and box your final answer. What is the absolute pressure, in SI unit, of a fluid at a gauge pressure of 1.5bar if atmospheric pressure is 1.01 bar?
The manometer shown in the figure below, uses mercury as its fluid. If atmospheric pressure is 100 kPa, what is the pressure of the gas in the container shown on the left?
Propose a suitable experiment to demonstrate that rate of diffusion is density dependentprocess. Your answer must include the following1. Experimental set-up2. Supposed calculation (if any)3. Precautions
Please solve and answer the problem correctly please. Thank you!!
A pitot tube (the figure) is used to determine the airspeed of an airplane. It consists of an outer tube with a number of small holes B (four are shown) that allow air into the tube; that tube is connected to one arm of a U-tube. The other arm of the U-tube is connected to hole A at the front end of the device, which points in the direction the plane is headed. At A the air becomes stagnant so that và = 0. At B, however, the speed of the air presumably equals the airspeed B of the plane. A pitot tube on a high-altitude aircraft measures a differential pressure of 240 Pa. What is the aircraft's airspeed if the density of the air is 0.0330 kg/m³? Number Pair- Hole A B B Units Liquid Air h
Show all work and give explanation
Direction: Solve the following problems. Show your complete solution and box your final answer.The weight of1 liter of gasoline is 7 N. Determine its density.
Please provide details about your resolution process. Please show complete, organized and correct work for each question. 2. A cylindrical object—with radius R, length L, and density ??—sits on a scale at the bottom of vat of fluid with density??.a. Draw and label a free body diagram for the object. (Don’t forget to set up a coordinate system and to label the acceleration info. Also, be sure to use the gridlines to help you draw arrows that show the correct directions and relative magnitudes of the forces. Finally, be sure to label your forces clearly to indicate the types of forces.)b. Use Newton’s 2nd Law to derive an expression for the reading on the scale.
Only round off in the final answer. Use three decimal places. As indicated in the illustration, an open rectangular tank rises upward along a 30o incline. What is the slope (tanθ) of the constant-pressure lines inside the tank?
TRUE OR FALSE. On the answer sheet, shade the circle for Letter A if the statement is correct. Otherwise, shade the circle for Letter E. I. 1. Boat floats because there is a force that is pushing it up. 2. Only the weight of the object determines if the object will sink or float. 3. If I change the shape of the clay, its weight and volume also change. 4. Cutting a wood in half will also make its density half of the original density. 5. The pressure exerted by the fluid at rest on an object is directly proportional to the density of the liquid and depth and is sometimes called as gauge pressure.
T00005/ruliscreen 12000703/View McGraw-Hill Campus - ALEKS Science O GASES Interconverting pressure and force A cylinder measuring 5.2 cm wide and 6.2 cm high is filled with gas. The piston is pushed down with a steady force measured to be 24. N. piston cylinder gas Calculate the pressure of the gas insids the cylinder. Write your answer in units of kilopascals. Round your answe to 2 significant digits. kPa Explanation Check 62021 McGraw-Hill Education. All Rights Reserved Terms of Use étv A FEB 28
Imagine two blocks as shown in Figure 10A-1. The two blocks, with the same size bases, are resting on the horizontal surface of a table. Each block pushes down on the underlying surface with a force (weight) that is ______ the downward force exerted by the other block.a.different fromb.equal toc.twice By definition, pressure is the amount of force acting on an area of surface. Pressure is calculated by dividing the force exerted on a surface by the area over which the force is applied. The blocks weigh the same and their bases have the same area, so the two blocks exert ______ pressure on the underlying surface.a.half theb.the samec.twice the