The voltage induced in a generator is 110 V when the armature rotates at 1100 r/min. What will the voltage be if the speed is increased to 1200 r/min? A generator operating at 1850 r/min develops a voltage of 130 V. What must be the speed of the generator for a voltage of 120 V?

The voltage induced in a generator is 110 V when the armature rotates at 1100 r/min. What will the voltage be if the speed is increased to 1200 r/min? A generator operating at 1850 r/min develops a voltage of 130 V. What must be the speed of the generator for a voltage of 120 V?

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: 13. A 200V DC Generator has a shunt field resistance of 200ohms. Its field current A) 1A B) 2A C) 3A…

Q: Mention what is the difference between generator and alternator?

A: It is asked to mentioned the difference between generator and alternator.

Q: 13. A 200V DC Generator has a shunt field resistance of 200ohms. Its field current A) 1A B) 2A C) 3A…

A: 13. Given data, Terminal voltage V = 200 V Field resistance Rf=200 Ω

Q: The diagrams show three generators. Which are alternating current Generators? coil rotation soft…

A: In a DC machine, the permanent magnet is used to generate the magnetic flux and a conductor is…

Q: I. Fill in the blanks. Write your answer in the space provided. 1. What is the numerical equivalent…

A: Note: We’ll answer the first question since the exact one wasn’t specified. Please submit a new…

Q: c) The O.C.C. of a DC shunt generator running at 300 rpm is as follows. 4 6. 7 Ir (A) Eo (V) 2 92…

A: It is given that: N=300rpm OCC Table:

Q: A 243.5 shunt Generator generates 4.5 Amps. Its Armature resistance is 1.1 Ohms. What is the…

Q: The current flows in the windings of the DC machine which causes the O Ohmic loss O Eddy current…

A: Given : Generally DC machines are those circuits which will converts the electrical energy into…

Q: c) The O.C.C. of a DC shunt generator running at 300 rpm is as follows. 3\ 132 6. 190 4 Ir (A) Eo…

Q: A 30kW generator has an armature resistance of 0.45 ohms, generates a terminal voltage of 225 V at…

A: 74.27 percent

Q: A 3-phase, 50 Hz, Delta-connected, AC generator has a stator with 60 slots, each slot contains 12…

A: In this question we will find induced line and phase voltage of delta connected generator...

Q: A 6 pole DC wave wound generator has 28 armature conductors with flux per pole is 23 mWb and the…

A: First option is correct. The explanation is provided below.

Q: The gas turbine, diesel motor and steam turbine are called the of a generator to produce…

Q: A DC generator with an armature resistance of 0.3 ohm and a shunt winding resistance of 125 ohm…

A: For generator , Armature current = Load current + shunt field current developed power = Armature…

Q: The following questions refer to to a 6-pole DC generator has a simplex lap-wound armature…

Q: PZ 4- A 4-pole generator has a wave-wound armature with 722 conductors and the armature current is…

Q: Exercise 5 The magnetization curve for a separately excited de generator is shown in Figure 1. The…

A: Given information about a separately excited DC generator is Rated output voltage is Vt=120 Volt.…

Q: The following questions refer to to a 6-pole DC generator has a simplex lap-wound armature…

A: It is given that: Number of poles=P=6288 coils of 1 turns eachResistance of each turn=0.01 ΩFlux per…

Q: Which of the following statements are true? I-If an alternating current is applied to a winding, an…

A: We are authorized to answer three subparts at a time since you have not mentioned which part you are…

Q: The 50kW, 500V short compound DC generator has an armature resistance of 0.06 Ohms, a series field…

Q: Shunt generator running at 2000 rpm, if flux is reduced by half, then what is the new speed * 1000…

A: Let us find the new speed using the emf equation used in the case of dc generator.

Q: The torque developed by a dc series motor is 44 N-m when drawing 17 A. If the current is doubled,…

Q: Exercise The armature of a 8-pole, 400 r/min generator, has 80 slots. Each coil has 6 turns and the…

Q: A 3-phase, 60 Hz, Y-connected, AC generator has a stator with 60 slots, each slot contains 12…

A: AC generators are used to generate electrical energy. It converts mechanical energy in the shaft to…

Q: A 3-phase, Y-connected, AC generator has a stator with 120 slots, each slot contains 15 conductors.…

A: Principle of Machine: In any electrical machine either it's a DC machine or AC machine, the EMF in…

Q: A 3-phase, Y-connected, AC generator has a stator with 60 slots, each slot contains 120 conductors.…

A: Need to find the number of turns per phase

Q: The torque developed by a dc series motor is 32 N-m when drawing 17 A. If the current is doubled,…

Q: A short composite motor draw or pulls stream a current of 50 A at a voltage of 220 V it rotates at…

A: A short composite motor is nothing but a short shunt compound motor. The given parameters for a…

Q: I. Fill in the blanks. Write your answer in the space provided. 1. What is the numerical equivalent…

Q: A 3-phase, 6-pole, Y-connected, AC generator has a stator with 48 slots, each slot contains 60…

A: In this question we will find synchronous generator electrical and mechanical frequency in rad per…

Q: The following questions refer to to a 6-pole DC generator has a simplex lap-wound armature…

Q: 4- A 4-pole generator has a wave-wound armature with 722 conductors and the armature current is 60…

Q: A certain generator has armature resistance of 0.080 Ω and develops an induced emf of 120 V when…

A: Given data: Armature resistance, ra = 0.08 Ω Induced emf, Eg = 120 V Armature current, Ia = 50 A

Q: A DC generator has eight poles, wound as lap then rewound as a wave, calculate the electrical motive…

A: In this question, DC Generator , Number of pole P= 8, Number of conductors Z= 240 Flux = 0.04wb…

Q: The shaft of a three-phase synchronous generator is rotating at 3000 RPM synchronous speed. This…

A: In this question , we will find efficiency of generator.....

Q: The resistance of the field of a shunt generator is 30 Ohms. Determine current in the winding when…

A: Given that voltage across shunt field winding (V) = 115V resistance of shunt field (R) winding =…

Q: The torque developed by a dc series motor is 12 N-m when drawing 23 A. If the current is doubled,…

A: Need to find new torque

Q: A short shunt compound generator has the following armature, series field and shunt field…

Q: Ohmic loss

Concept explainers

Three Phase Induction Motor

The induction motor is an electric motor that runs on AC (alternating current) and it is of two type single phase motor that work on single-phase power supply and three-phase motor that work on three-phase power supply.

Question

The voltage induced in a generator is 110 V when the armature rotates
at 1100 r/min. What will the voltage be if the speed is increased to
1200 r/min?
A generator operating at 1850 r/min develops a voltage of 130 V. What
must be the speed of the generator for a voltage of 120 V?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A shunt generator delivers 1,000 W at 149 V to a load. If the armature resistance is 0 ohm, and the shunt field resistance is 56 ohms, calculate the shunt field current in ampere.
The bearings and commutator rotation of the DC machines which causes the O Hysteresis loss O Ohmic loss O Friction loss O Eddy current loss
The torque developed by a dc series motor is 16 N-m when drawing 23 A. If the current is doubled, the torque developed becomes N-m.
I. Fill in the blanks. Write your answer in the space provided. 1. What is the numerical equivalent of 120 electrical degrees of a three-phase electrical machines 2. It is the other term used to describe AC generator. 3. Increase the speed of rotor to increase frequency, while increasing the field excitation will increase the 4. It is an electrical instruments used to view the waveform of DC or AC voltages. 5. In a delta-connected three-phase generator, its line voltage is equal to II. Problem solving. Solve the following problems. 1. Calculate the effective voltage of a wye-connected alternator per phase, given the following values: Ø = 2.01 lines, f = 50 hz, kp = 0.98, ka = 0.97 and T = 250 turns per phase. Note: 1Wb= 100,000,000 lines 2. Compute the root-mean-square value of voltage in a delta-connected alternator with 200 volts per phase.
A 4-pole generator has a wave wound armature with 730 conductors and it delivers 110 A on full load. If the brush lead is 10 degrees mechanical, calculate the cross-magnetising ampere turn per pole.
What is the operation of a dc generator? Create a bulleted set of information
A 220V series generator has an armature resistance of 0.4Ω. If the generated emf is 230V and the drop across the series field winding is 8V, what is the power (in watts) to the load? use two decimal places if the answer is not exact and do not include the unit anymore.
please help
A 3-phase, 60 Hz, Y-connected, AC generator has a stator with 60 slots, each slot contains 12 conductors. The conductors of each phase are connected in series. The flux per pole in the machine is 0.05 Wb. The speed of rotation of the magnetic field is 720 RPM. What are the resulting RMS phase voltage and RMS line voltage of this stator? Select one: O a. V = 2262.0 Volts and Vr = 3917.8 Volts O b. V = 2770 Volts and VT = 2770 Volts O c. Vộ = 1599.4 Volts and VT = 1599.4 Volts O d. V = 1599.4 Volts and VT = 2770 Volts O e. None
A shunt generator delivers 1,000 W at 149 V to a load. If the armature resistance is 0 ohm, and the shunt field resistance is 56 ohms, calculate the shunt field current in ampere.
Please quick solution