Show that(KrP – BT)VKr = Isothermal compressibilityB = volume expansivityThe vapour pressure, p, of a gas varies with temperature as follows:T/K1125117512251275|p (Pa)400140032807100Evaluate the enthalpy of vaporization and also the vapour pressure of gas at 1250 K.

The enthalpy of vaporization can be defined as that minimum amount of energy that must be supplied…

The vapour pressure, p, of a gas varies with temperature as follows: 1175 1400 1225 T/K |p (Pa) 1125 1275 400 3280 7100 Evaluate the enthalpy of vaporization and also the vapour pressure of gas at 1250 K.

The vapour pressure, p, of a gas varies with temperature as follows: 1175 1400 1225 T/K |p (Pa) 1125 1275 400 3280 7100 Evaluate the enthalpy of vaporization and also the vapour pressure of gas at 1250 K.

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

At 25 °C, the vapour pressure of pure benzene is 12.8 kPa and the vapour pressure of pure methylbenzene (toluene) is 3.8 kPa. Consider a liquid mixture with mole ratio 30% benzene-70% methylbenzene, which you can treat as an ideal liquid mixture, in a closed container. a) Calculate the mole ratio of benzene and methylbenzene in the vapour.
Acetone has a vapour pressure of 53.3 kPa at 39.5 °C and 202.6 kPa at 78.6 °C. From the above data, obtain an equation to correlate the vapour pressure of acetone. (The equation should be in the form In(P)= -A/T + Co where P, is in kPa units. Find numerical values for A and Co) A= 5756 K, Co = 17.989 A= 4756 K, Co = 16.989 A= 3756 K, Co = 15.989 A= 2756 K, Co = 14.989
Equilibrium is established between ice and water at 0°C. An experiment has been conducted to disturb the equilibrium by increasing the pressure from 1 bar to 5 bar, If the density of water at this condition is p- 0.999 g/ cm and for the ice p- 0.917 g/ cm. calculate the change in chemical potential for liquid water. (1 bar 10 pa) 1.97 mol -1.80 Jmol 7.21 mol +1.97 Pmol
A saturated solution of copper(ll) sulfate, with excess of the solid, is present in equilibrium with its vapour in a closed vessel. (a) How many phases and components are present? (b) How many degrees of freedom are available, and what are they?
2) Draw the isobaric phase diagram at 1 atm of the following two-component liquid system: water (Boiling point = 100°C) and nitric acid (Boiling point = 86°C), with the mass percentage of nitric acid on the x-axis. When the liquid mixture contains 68 % nitric acid, an azeotrope with a boiling point of 120.5°C, is formed. Use the sketch to describe under which conditions pure nitric acid can be obtained by means of isobaric distillation.
We discussed the temperature-composition phase diagram for a binary system given below. Mole fraction for B at key points are indicated. °C P = 1 Vapour b, 80 P = 2 P= 2 Liquid P = 1 Liquid P= 2 10- Qa, 0.70 XB 0.20 Mole fraction of B, 0.85 0.9 Starting from point a, of the binary mixture, what is the mole fraction of component B in the vapor when the mixture begins boiling? 0.20 0.90 Uncertain, since more information is needed. 0.85 0.70 ООООО Temperature, T
A solution containing 30 g of non-volatile solute exactly in 90 g of water has a vapour pressure of 2.8 kPa at 298 K. Further 18 g of water is added to this solution. The new vapour pressure becomes 2.9 kPa at 298 K. Calculate:(i) the molecular mass of solute and(ii) vapour pressure of water at 298 K.
Establish the phase equilibrium for nonreacting systems in terms of the specific Gibbs function of the phases of a pure substance
1.Calculate the effect (change) on the chemical potential for liquid carbon dioxide, which had an increase in pressure of 1.00 bar, and whose density is 2.35 g.cm Temp 0 C 2.Calculate the effect of an increase in pressure (i.e. percent increase) of 100 bar on the vapor pressure of benzene (C6H6) at 5°C. Density of benzene is 0.879 g.cm3.
In this table you can find the composition and total vapour pressure of a benzene-toluene solution at 120 ºC:
Looking at the following image of a curve of partial pressures vs mole fractions of the two components A and B of an ideal mixture of liquids that obeys Raoult's Law where pa and pe are the partial pressures of the two liquids A and B respectively and xa and xg are the mole fractions of A and B respectively, which of the following statements is true? PA Pa R S A. The intercepts R and S are representative of the equilibrium vapour pressures of the components A and B respectively B. The intercepts R and S are representative of the equilibrium vapour pressures of the components B and A respectively C. The slopes of the two curves, red and blue, are representative of the equilibrium vapour pressures of the components A and B respectively D. Both (B) and (C) E. The slopes of the two curves, red and blue, are representative of the mole fractions of the components A and B respectively
It is well known that the temperature at which water freezes to ice or boils at a pressure of 1 atm, are 0°C and 100°C. In the next two tasks, we will now investigate what the temperatures would be at the top of Mount Everest, where the pressure is only 0.337 bar. The standard molar enthalpy of fusion of water at 0°C is ΔfusHmo = 6.008 kJ mol-1 and the standard molar enthalpy of vaporization of water at 100°C is ΔvapHmo = 40.656 kJ mol-1. The density of liquid water at 0°C is ρ(l) = 999.9 kg m-3, while the density of ice at 0°C is only ρ(s) = 916.2 kg m-3. The densities and enthalpies are assumed to be independent of temperature. 1) Calculate the temperature at which ice melts on top of Mount Everest. 2) Calculate the temperature at which water boils on top of Mount Everest.