Answered: The units are given as mechanical units… | bartleby

Related questions

Question

Major:

Electrical Engineering

Course: EE350 ( System Dynamics and Control )

The units are given as mechanical units in the electrical circuit
which is given as the analogy of a mechanical system. In this system, find the
fv2 / f (t) transfer function.
1
K|
1
M1
fvi
M2
K3
HE
fvz
v,(1)
K2
V½(1)
WHE

Expert Solution

Step by step

Solved in 6 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Blurred answer

Similar questions

1. Given the mechanical system below, a. show the network equivalent of the system b. get the transfer function x1(s)/f(s) K₁=1 N/m oooo fv₁ = 2 N-s/m x₁ (t) K₂=1 N/m 0000 M₁=1 kg ₂-1 N-s/m + x₂ (1) f(t) = M₂=1 kg 31 N-s/m
A. Three resistors with resistances of 9 Ω, 18 Ω, and 30 Ω are in a series circuit with a 12 volt battery. What is the total resistance of the resistors in the circuit? B. What is the current flow through the resistors in #7 above? C. What is the total power of three 10 ohm bulbs when they are connected in a 12 volt series circuit?
Create a schematic diagram of given circuit connection. 1.A given uses an AC voltage source, an SPST toggle switch and a ligh bulb/lamp as a load.
a) Find the magnitude of the current through the 20.0 Ω resistor. b) Find the direction of the current through the 15.0 Ω resistor. Circle one. Explain your answer below. The current goes toward the lower right of the circuit OR toward the upper left of the circuit. c) Find the voltage drop across the 10.0 Ω resistor.
A 95-W light bulb operates on an effective ac voltage of 110 V. a) What is the effective current through the light bulb? b) From Ohm's law, what is the resitance of the light bulb?
Please help me with this physics lab
If a lamp has resistance of 120 W when it operates at 100 W, what is the applied voltage? a. 110 V b. 120 V c. 125 V d. 220 V
In the circuit shown in the figure, VA = VB = 10.0 V and R₁ = R₂ = R3 = R4 = R5 = 100.0 £2. Current 15 flows up through R5, and I5 = 0.0250 A. Determine the current I4 through R4. Assume the direction of positive current flow is downward through R4. 14= = Determine the voltage V₂ across R₂. V₂: = Determine the power P3 dissipated by R3. P3 = A V W www R₁ R₁ ww R₁ 4 V. B R₂ R₂
A wire of variable cross-section is given below. The relation between the drift speeds on the two cross-sections 1 and 2 is За Select one: a. Va2=Vd1 b. 9V12=Vd1 c. Vd2=2V41 d. 3V42=2V11 TP e. 3V12=Vd1
Circuit Problem: Express each labelled voltage and current (e.g., vx, ix) in terms of the resistances and source currents and voltages (e.g., R0).