The unit flow rate passing through a wide channel is 6.0 m2/s. As shown in the figure, the channel consists of three infinitely long sections with different slopes, and the base slopes of each section are shown on the figure. There is a fully closed vertically movable cover in the S01 inclined channel, and the water passes over the cover. The water depth formed just downstream of the cover is 0.6m, and the height of the relief structure at the beginning of the S03 inclined channel is 4m. What is the water depth at the beginning of the profile formed just downstream of the relief structure in the S03 inclined channel by taking the Manning coefficient of friction of 0.02?

Q: The rate of discharge through the canal in the figure below is to be 11 m³/s. Find the width b and…

A:

Q: 26. A trapezoidal canal with a base of 2.2 m has sides sloping at 45⁰ with the horizontal. If water…

A: A trapezoidal canal with a base of 2.2 m has sides sloping at 45⁰ with the horizontal. If water…

Q: A rectangular channel 3.7m wide conveys7.4m3/s of water at a depth of 300mm.If a hydraulic jump…

A:

Q: A channel has a slope of 0.2° with n=0.013. It is expected that the channel will be able to carry a…

A: Given data- Discharge (Q) = 25 m3/s n = 0.013 Slope (S) = 0.2o Bottom width (B) = 1.5 m Density of…

Q: A hydraulic jump occurs in a rectangular channel having a discharge of 3.45 m^3/s of water per meter…

A: as per guidelines provided to us we are restricted to solve only 1 question if multiple question are…

Q: Water flows at a rate of 12 m/s through an almost level channel 3 m wide. The depth gradually…

A: Given:- flow rate=12m3/secwidth of level channel=3mdepth increases =1m to 1.1mlength of flow=5mTo…

Q: A compound channel has the cross-section shape shown in Figure 2 below. Figure 2: Engineered…

A: Given: Bed slopeS=0.018 Manning's n for rectangular central channeln=0.025 Manning's n for upper…

Q: Design a semi-circular open channel (n=0.014) that is anticipated to convey 10cumecs of water. The…

A:

Q: T2. As depicted in the figure, two channels of different shape have the same cross sectional area,…

A:

Q: 4. A rectangular channel 3 m wide carries water at a depth of y1 = 1.6 m and a velocity v1 = 1.75…

A:

Q: i) Determine the critical depth of flow for this channel. ii) Determine the normal depth of flow for…

A: Critical depth hc =q2g1/3Here q discharge per unit width and g is acceleration due to…

Q: A masonry dam having a sheet piling cutoff at the upstream and is located at a reservoir site as…

A:

Unit Conversion

Standard units are also called SI units. SI units are used for measuring a physical quantity satisfying certain conditions. There are two types of units: fundamental units and derived units. Fundamental units are physical quantities that are independent, that is, they do not depend on other quantities like mass, length, or time. There are plenty of quantities in our lives which need to be measured and compared. Measuring is the comparison of a particular physical quantity with its reference value. A unit is a measure of a fixed physical quantity. A physical quantity is the product of a unit and the numerical value we need to compare with.