A hydraulic jump occurs in a rectangular channel having a discharge of 3.45 m^3/s of water per meter width. The approach depth is 0.745m Compute the Froude number after the jump Choices: A. 1.26 B. 0.62 C. 1.62 D. 0.26

Q: An open channel of trapezoidal cross section, 2.5m at the base and sides inclined at 60° to the…

A: Given: The base width is 2.5 m. The side angle is 60o. The bed slope is 1 in 500. The flow rate is…

Q: At the foot of a spillyway, water flows at a depth of 23 cm with a velocity of 8.1 m/s, as shown in…

A:

Q: Design a trapezoidal channel to carry a discharge of 1000 cfs. The channel laid on a slope of 0.0015…

A: to find - design the trapezoidal channel

Q: A trapezoidal channel with 3.0m bottom width and 1:1 side slope carries a discharge of 10 m³/s at a…

A:

Q: Problem 3. A 3 m wide channel with a rectangular cross-section is carrying a flow with flow rate Q =…

A: Given data, Channel section is rectangular Discharge = 9 m^3/s Width = 3 m Specific energy = 2 m

Q: Given that Q = 20 m3/s, calculate the flow depth of the stream after the scour hole.

A:

Q: Q2. The rectangular channel shown in the Figure is horizontal, and it carries q = 10 cfs/ft. The…

A:

Q: Water discharges from under a sluice gate into 10 m wide channel (slope = 0.001) at a flowrate of 28…

A: b=10 mChannel slope=0.001Q=28 m3/sAssume n = 0.015

Q: Water flows in a 1.5-m wide rectangular channel with a constant bed slope So = 0.144 (see figure…

A:

Q: Water flows at a rate of 12 m/s through an almost level channel 3 m wide. The depth gradually…

A: Given:- flow rate=12m3/secwidth of level channel=3mdepth increases =1m to 1.1mlength of flow=5mTo…

Q: Determine the difference of energy grade line and hydraulic grade line of an open channel with…

A: Given data in question  Discharge  Width Depth To find out  Difference between EGL and HGL

Q: Fluid Mechanics question: Water flow from a pone through a 10cm diameter pipe. Find the flow rate…

A: Given: Elevation of point ‘A’ from ‘B’ = 10               Diameter of the pipe = 10cm

Q: 8.15) The flow rate and water depth just upstream of a dam are 15 m³/s and 4.0 m respectively. The…

A: Reference : Fluid mechanics, Rectangular Channel section. Given : Flow rate, water depth, width ,…

Q: 5) A trapezoidal channel lined with stone (n=0.024) has a bottom width of 2.44 m, side slopes of 2.5…

A:

Q: Sketch GVF problems 1.A 9.0 m wide rectangular channel has its longitudinal bed profile shown below.…

A:

Q: hydraulics *use handwritten    A rectangular channel 5.50 m wide and 1.30 m deep is laid on a…

A:

Q: A concrete lined (n = 0.013) trapezoidal channel has a bed slope of 0.00152 and it carries a…

A: Trapezoidal channelManning coefficient (n) = 0.013Bed slope (S) = 0.00152 Discharge (Q) = 8 m3/s…

Q: For the channel shown assume a = 1m, b = 3m, d = 2m, w = 8m and n = 0.015, what bed slope is…

A: ASKED: To determine the bed slope of the channel for given flow parameters and cross-section.…

Time and time related variables in engineering

Time is the event progression starting from past to present and then, future statistically. The time-related variable is any particular value in relation to time to assess its changes on a specified (XY) plane.