Answered: The uniform 17-kg plate is welded to… | bartleby

Related questions

Question

The uniform 17-kg plate is welded to the vertical shaft, which is supported by bearings A and B. Calculate the magnitude of the force
supported by bearing B during application of the 100-N-m couple to the shaft. The cable from C to D prevents the plate and shaft
from turning and the weight of the assembly is carried entirely by bearing A.
100 N·m
180 mm
120 mm
500 mm
230 mm
480 mm
C.
Answer: B =
i
kN

Expert Solution

Trending now

This is a popular solution!

Step by step

Solved in 5 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Blurred answer

Similar questions

6m T 10m A 8m Figure 4 A B 6. A horizontal beam AB of mass m = 20kg is supported from end B by a cable and hinged to a A vertical wall at end A. Calculate the magnitude of the tension T in the cable when Batman, who has a mass M = 80 kg, stands midway along the beam. What are the x and y components of the force at the hinge?
A horizontal 4.0 m long 5.0 N uniform bar at one end is attached to a wall by a frictionless hinge; and at the middle of the bar there is a vertical cable pulling down 7.0 N, and at the middle of the bar there is also a cable that is at 45 ° to the horizontal pulling up as shown. ii) What is the magnitude of the horizontal component of the force on the bar due to the hinge?
A uniform beam of length L = 11.7 meters and mass of 109.3 kg is pinned at one end and is being supported by a wire as shown. The wire is connected to the beam x = 3.3 meters from the pin. A person of mass 81.6 kg is standing all the way out on the edge of the beam. If θ = 17.3 degrees and φ = 79.4 degrees, what is the tension in the wire?
A ladder is leaning against a vertical wall, and both ends of the ladder are at the point of slipping. The coefficient of friction between the ladder and the horizontal surface is ?1=0.165 and the coefficient of friction between the ladder and the wall is ?2=0.153 . Determine the maximum angle α with the vertical that the ladder can make without falling on the ground.
45 kg.…* X = ? +0.4 m -0.5 m→ 30 kg 40 kg The 3m long uniform plank is supported by a fulcrum at the midpoint. Where should a 45kg student must be from the midpoint to be able to balance the plank?
A person pushing a horizontal, uniformly loaded, 26.90 kg26.90 kg wheelbarrow of length ?L is attempting to get it over a step of height ℎ=0.470?,h=0.470R, where ?R is the wheel's radius. The center of gravity of the wheelbarrow is in the center of the wheelbarrow. What is the horizontal component ??Px of the minimum force ?⃗ P→ necessary to push the wheelbarrow over the step?
A 18.5 kg door that is 1.02 m wide opens slowly as a pull of constant magnitude 53.3 N is exerted on the doorknob. This applied force, which is always perpendicular to the door, is necessary to balance the frictional torque in the hinges. How large must an applied force of constant magnitude be in order to open the door through an angle of 90.0° in 0.474 s?
Question 4: A box (M = 140 kg) is sitting on a 6.0 m light uniform board (with negligible mass). The board is supported by two pivots one at each end. The box is sitting x = 1.6 m from the left side of the board as shown. What is the magnitude of the normal force produced by the pivot at the right end (ng) measured in Newtons? M 6.0 m- /В DB