The uniform 100-kg I-beam is supported initially by its end rollers on the horizontal surface at A and B. By means of the cable at C it is desired to elevate end B to a position 3 m above end A. Determine the required tension P, the reaction at A, and the angle 0 made by the beam with the horizontal in the elevated position. 6 m C 2m B A

Q: 10 m 0.5 kN downward 0.5 kN upward 5 kN-m C

A: Option b is correct.

Q: Determine the horizontal and vertical components of the reaction at pin A and the reaction of the…

A: Given Data- A beam given with uniform weight w=1400N We have to find reaction at support

Q: The uniform 15-m pole has a mass of 150 kg and is supported by its smooth ends against the vertical…

A: Given:m=150 KgL=15 m

Q: The overhanging beam is supported by a pin at A and the two-force strut BC Determine the horizontal…

A:

Q: Based on the attached figure: (a) Determine the force acting on the hydraulic cylinder BC. F(BC) = ?…

A:

Q: Question 6 Neglecting the weights of the bar and the pulley and assuming the weight of the ball B to…

A:

Q: Question 3 (Type B): The 50 N force F is parallel to the y axis. Determine the components of the…

A: The force F is

Q: Member ABC is rigidly fixed to the collar at A. The collar can slide freely on the pole and can…

A:

Q: Q4A: Calculate the forces in members AG,AB, CG, GF and CF for the truss shown. 2 kN C 2 m D 4 kN 2 m…

A: To calculate the forces in the member AG, AB, CG, GF, CF

Q: Turnbuckle T₁ is tightened to a tension of 160 lb and turnbuckle T₂ is tightened to 98 lb. Determine…

A: As per the Bartleby code of conduct, it is recommended to answer the three subparts of a multiple…

Q: Suppose P = 2500 lb. From the frame below, determine the magnitude and direction of the vertical and…

A:

Q: Determine the reactions at A and B. 400 lb/ft 6 ft 4 ft- H .6 ft 300 lb/ft B

A:

Q: Find the reactions at the fixed support A given the distributed loads shown. (+)+ 1 = (d) 1 = su A y…

A: Step 1:Step 2: Step 3: Step 4:

Slope and Deflection

The slope in a deflected beam is described as an angle in radians made by the tangent of the section with the original axis of the beam. The deflection at any point on the axis of the beam is defined as the lateral displacement of the point before and after loading.