The trash can distributed by the city of Mobile are approximately 4 feet tall and have a square cross section with a side of 30 inches. WHat is the capacity of the rectangule in gallons?

Q: Density and viscosity oleic acid at 20 degree celcius and 1 atm

A: Oleic acid is an mono-unsaturated long chain fatty acid which is generally found in liquid state at…

Q: Use water as a drilling mud to drill a well to a depth of 3000 feet , calculate the pressure…

A: This question is based on pressure gradient. The data given are: Depth = 3000 feet

Q: ind modulus of elasticity of a brass rod of length 200 mm which is subjected to a tensile stress of…

A:

Q: 16. What is the unit of resistance in SI? O w O W/K O m-K/W O W/m^2-K O K/W

A: Asked;  SI unit of resistance

Q: A single crystal of a metal is oriented for a tensile test such that its slip plane normal makes an…

A: Given,

Q: Ex: A well is need to be drilled to 15,000 ft. The entrance into abnormal pressures at 10,000 ft are…

A:

Q: Fraction of water

A: To Answer whether the fraction of water in the underflow stream of thickener is zero

Q: drag force

A:

Q: Why do positive displacement pumps cause pose more overpressure hazard compared with centrifugal…

A: In a positive displacement (PD) pump, a fixed volume of liquid is trapped inside an enclosed chamber…

Q: The computed stress should be lower or equal to the allowable stress for the material to be safe in…

A:

Q: Strain is d Both a O chang O chang O O O

A: Introduction: Strain: It is defined as the amount of deformation that a body experiences on the…

Q: The soil is uniform if the coefficient of uniformity Cu close to: O 1.0.1 O 2.2.0 O 3.1.0 O 4.1.5

A: Uniformity coefficient (Cu) is the ratio of Grain Diameter (D60) to Grain Diameter (D10).  Soil are…

Q: pipe, g/cm', and the melt has a dynamic viscosity of 3.12 g

A: 1. diameter= 10cm = 10*10-2m 2. Density = 7.8 g/cm3= 7800 kg/m3 3. dynamic viscosity= 3.12g/ms=…

Q: 3.) A steel bar 100 mm long and having a square cross section 20 mm on an edge is pulled in tension…

A: Given: Length of steel bar=100 mm=100×10-3mCross section of the steel bar=20 mm=20×10-3mForce=89000…

Q: If the entering velocity is 6 m/s, calculate the length of tube and determine whether the process is…

A:

Q: On Mars, people live in domes. The outside of the dome walls are made of aluminium. However, the…

A:

Q: Consider a colloid particle whose dimensions are 50x30x10 µm. Calculate the surface to volume…

A: Given data: Dimension of colloid particle = 50 × 30 × 10 μm

Q: A solute is diffusing through a membrane with 1 cm? surface area. After 1 min, 15 mg has crossed the…

A: Given data: Surface area of membrane = 1 cm2 Mass of solute crossed the membrane in 1 min = 15 mg…

Q: 7.4 A normally consolidated clay is consolidated under a triaxial chamber con- fining pressure of…

A: It is given that normally consolidated clay is consolidated under a triaxial chamber .Confining…

Q: ne equivalent permeability of four beds in series, having equal formar thickness under the following…

A: To calculate Equivalent permeability of four beds in series having equal formation thickness under…

Q: Use the accompanying phase diagram for carbon to answer the following questions.a. How many triple…

A: Note: Note: We are authorized to answer three subparts at a time, since you have not mentioned which…

Q: 5. Absolute pressure is measured relative to atmosphere. Tor F

A: Absolute pressure is measured relative to a full vacuum Whereas the pressure that is measured…

Q: (a) Is flow in the boundary layer laminar or turbulent at the end of the plate, L = 2 m? (b)…

A: To tell the boundary layer laminar or turbulent we use a dimensionless number called Reynolds Number…

Q: what is the actual air required per hour.

A: Ultimate and proximate analysis of the coal sample is given. Flow rate of coal = 11762 kg/h % Excess…

Q: What

A: The hydrosphere is combined mass of water on ,above and below surface of earth.

Q: What is the maximum radial distance traveled by any particle in cyclone seperator?

A: Chemical processes consist of the separation stages in which the process streams are separated and…

Q: Suggest and discuss 1(ONE) example of hard materials that is suitable for improving abrasive wear…

A: Hard materials are particularly suited for challenging circumstances like ploughing, mining, rock…

Q: A system asshown in the figure is used to measure accurately the pressure changes when pressure is…

A:

Q: Derive the three laws of crushing from fundamental equation

A:

Q: A) A spherical particle of diameter 10 mm and density 3500 kg/m, was falling through a liquid of…

A: The settling velocity of the particle in the liquid is to be determined.

Q: The figure shows the stress strain graph for 4 materials: 1) the most ductile is? 2) the most…

A: 1) 'C' is the most ductile.More the area under the curve more the ductile. 2) 'B' is the most…

Q: wire 10 m long has a cross-sectional area 1.25 x 10-4 m2. It is subjected to a load of 5 kg. If…

A: As we know  Youngs modulus = stress/strain  Stress= force/area  Strain= change in length /initial…

Q: Calculate the net force acting on the cone in Figure 4.69. Im Water 3 m Figure 4.69 System for…

A: