A cylindrical pressure vessel of radius r = 10.2 in is filled with a gas at a pressure of 455.0 psi (gauge). The top of the vessel is secured by an end cap of radius R = 22.0 in, of weight 31.0 lbf, and held in place by 14 bolts. Bolts (more exist t End cap

Q: Use water as a drilling mud to drill a well to a depth of 3000 feet , calculate the pressure…

A: This question is based on pressure gradient. The data given are: Depth = 3000 feet

Q: Calculate the density of oxygen gas at a temperature of 57 C and a pressure of 5 MPa.

A: Density of oxygen at 570C and 5 MPa is asked

Q: Describe the difference between average pressure and false pressure

A: The force applied perpendicular to the surface of an object per unit area over which that force is…

Q: Example 7.2: A simple U-tube manometer is installed across an orifice meter. The manometric fluid is…

A: U tube manometer is the simplest pressure measuring devices and are used for measuring low pressure…

Q: 2-3. Suppose an incompressible fluid flows in the form of a film down an inclined plane that has an…

A: An incompressible fluid flows in the form of film down an inclined plane.

Q: drag force

A:

Q: Slug flow of pipes

A: Slug flow is a type of multi-phase flow. Multi-phase flow is simply fluid flow which contains…

Q: A particle 'A' of diameter 10 microns settles in an oil of specific gravity 0.9 and viscosity 10…

A:

Q: 3.) A steel bar 100 mm long and having a square cross section 20 mm on an edge is pulled in tension…

A: Given: Length of steel bar=100 mm=100×10-3mCross section of the steel bar=20 mm=20×10-3mForce=89000…

Q: Brine (SG = 1.1) is flowing through a 100-mm ID smooth pipe at a Reynolds number of 48000. The…

A:

Q: This factor is usually neglected on calculation for pressure drop. A Acceleration B Elevation…

A: Pressure Drop: Difference of total pressure between two point in a fluid flow network is called…

Q: A nozzle is bolted onto a pipe by the flanged joint as shown in the Agure. The flowing fluid is…

A:

Q: 3.10. For steady flow in a circular pipe, the average velocity is given by Vaverage = 2 = √r A…

A:

Q: An oil film drains steadily down the side of a vertical wall, as shown on figure below. After an…

A: Oil film is steadily sliding down on a vertical wall and as it reaches down its thickness increases…

Q: / Air ine room with dimensions are 4 mx 6 m x 3.5 m have density of air is 1080 g/m². Calculate the…

A: We know  that, Density = Mass/ Volume Where,  Density = 1080 g/m3

Q: In the figure below, a tube with a modulus of elasticity of 1 MPa is anchored between two stationary…

A:

Q: 2.3.2 Floating of Wood on Water A rectangular piece of wood (density = floats on water (density =…

A: The rectangular piece of wood floats on the water surface. part of wood goes inside the water due to…

Q: A mirror produces an image that is located 41.0 cm behind the mirror, when the object is located…

A: Given : The image distance, Object distance,

Q: Magnitude of the resultant force of the coplanar system

A: We will calculate the magnitude of resultant force of the co-planar system by using Rectangular…

Q: A system asshown in the figure is used to measure accurately the pressure changes when pressure is…

A:

Q: 5.1-2. Frictional Pressure Drop in a Flow of Olive Oil. Calculate the frictional pressure drop in…

A: Olive oil density and viscosity at a given temperature are obtained. The Reynolds number is…

Q: A reservoir of 1300 ft radius with 42 ft thickness experiences a drop in fluid pressure from 5300…

A: Given,initial porosity of reservoir, φ1=16.4%=0.164formation compressibility ,Cf=4×10-5…

Q: As flowmeters, these devices are most widely used. They most often also have ★ integral temperature…

A: As flowmeters, these devices are most widely used. They most often also have integral temperature…

Q: Calculate the net force acting on the cone in Figure 4.69. Im Water 3 m Figure 4.69 System for…

A:

Q: A 1-m deep, open container is filled with an unknown fluid. The absolute pressure of the fluid at…

A: The specific gravity of the fluid is the ratio of the density of the fluid to the density of the…

Q: The U tube shown is rotated about the left vertical leg at 30 rpm. The pressure at point A is…

A:

Q: A hydrometer is calibrated such that in pure water it reads exactly 1.0 at the air- water interface.…

A:

Q: 6. A 3-kg rock is thrown upward with a force of 200 N at a location where the local gravitational…

A:

Q: Calculate the pressure gradient due to gravity in water, in psi/ft. Most experienced engineers round…

A: The pressure gradient due to gravity in water is calculated as follows:Determine the density of…

Q: separated from the plane with a film of oil of thickness 1.5 mm. The plate weighs 30kg and slides…

A:

Q: Q: A string has a diameter of 1 cm and the original length of 2 m. The string is pulled by a force…

A: The change in length of the string is to be determined.

Q: On which factors does the liquid composition at the bottom of the tower depends?

A: Packed tower are the mass transfer device are composed of packing material having high surface area…

Q: A load of 200lb is hung from the middle of a rope, which is stretched between two rigid walls 50…

A: A few assumptions need to be made to solve this problem. The forces acting in the upward direction…

Q: Pressure is expressed as the equivalent O True O False height of a fluid column.

A: Pressure is defined as the ratio of force acting per unit area. P = ForceareaP = mgA

Q: An elevator with a mass of 2500Kg rest at a level 10m above the base of an elevator shaft. It is…

A: