The thyristor is triggered using the pulse transformer. The pulse transformer operates at 10 KHZ with a duty cycle of 0.4.The gate voltage allowable limit of 10 volts. By the equivalent circuit of thyristor, the collection current of the first transistor is 0.5A, the collection current of the second transistor is 0.2A, a, and az are 0.3 and 0.5 respectively. Find the maximum average gate power dissipation. Assuming the thyristor is ideal.

The thyristor is triggered using the pulse transformer. The pulse transformer operates at 10 KHZ with a duty cycle of 0.4.The gate voltage allowable limit of 10 volts. By the equivalent circuit of thyristor, the collection current of the first transistor is 0.5A, the collection current of the second transistor is 0.2A, a, and az are 0.3 and 0.5 respectively. Find the maximum average gate power dissipation. Assuming the thyristor is ideal.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

I need the answer as soon as possible
ans fast please
I need the solution quickly with in 15 minutes
Explain the working of single phase full converter for RLE load discontinous mode o operation with neat sketch, waveform and equations.
A silicon controlled rectifier (SCR) has a forward breakdown voltage of 230 V. When a gate current of 2 mA flows in the gate circuit. If a sinusoidal voltage of 400 V peak is applied, find the following: Firing angle. Average output voltage. Average current for a load resistance of 180 Ohms. Power output
I need the answer as soon as possible
A PWM signal changes with a voltage of -15 and 15 volts while it is desirable to produce an effective (average) voltage of the PWM signal of 9 volts. The duty cycle that must be generated is
choose the correct answer 6-If the collector resistance is shorted,the ac output voltage willa-Decrease. b-Increase. c-Remain the same. d-Equal zero. 7-If input impedance of the second stage decreases, the voltage gain of the first stage willa-Decrease. b-Increase. c-Remain the same. d-Equal zero.
8-The waveform of output voltage of half-controlled three phase bridge rectifier in each cycle contains: Two- pulse six- pulse three- pulse 9-The DC supply voltage of single phase bridge inverter is 300V. For quasi-square wave output voltage with a 60 percent ON time, the RMS value of output voltage is: 232.37V 220.5V 270.9V 10-For three phase bridge inverter with 120° conduction and resistive star-connected load, the waveforms of: (a) The load current and line voltage are quasi-square. (b) The load current is quasi-square and line voltage is a six- step. (c) The load current is six- step and line voltage is quasi-square. 9.
A centre-tap full-wave rectifier (CT-FWR) is operated from a (60 Hz), (110 V,ms) line voltage through a transformer with turn ratio of ( = 2). It has a (2 k 2) load resistance. Assume Si diodes. 1. What minimum value of capacitance is required if the ripple must be no greater than 1%? 2. If the filter capacitor is changed to a (470 µF), what is the required load resistance to give the same ripple of 1%. 3. Determine the DC voltage on the load side. 4. What is the power dissipated and minimum PIV of each diode? 5. Draw the circuit diagram with output voltage waveform.