The three suspender bars are made of steel and have equal cross-sectional areas of 450 mm?. Determine the average normal stress in each bar if the rigid beam is subjected to the loading shown.

Q: 15 kip 15 kip 4 in. 4 in. 4 in. The beam has the cross section shown. Determine (a) the maximum…

A:

Q: For the connection shown, the average shear stress in the 14-mm-diameter bolts must be limited to…

A: Given is a double shear connection.

Q: ) If the load has a weight of 600 lb, determine the maximum normal stress developed on the cross…

A: An internal resisting force which is applied by the molecules of the object so that the shape of the…

Q: Steel wire AB and aluminum wire CA support the 400 kg mass as shown. Determine the required diameter…

A:

Q: Determine the resultant internal loading acting on the cross section BC of the frame show below…

A:

Q: Two equal and opposite couples of magnitude M = 23 kN-m are applied to the channel-shaped beam AB.…

A:

Q: Determine the average shear stress developed in the nails within region AB of the beam. The nails…

A: Step 1: Step 2: Step 3: Step 4:

Q: The beam is subjected to the loading shown. Determine the principal stress at point C.

A: Given data: The magnitude of the uniformly varying load is; ω = 8 kN/m. Evaluate the total load on…

Q: The pipe assembly is subjected to the loads shown. Determine the state of stress at point A on…

A: Given data, Let Ax, Ay and Az are the reaction force at A Bx and Bz are the reaction force at B Cz…

Q: If M=2.5kip.ft, determine the magnitute of the resultant force the bending stresses produce on the…

A:

Q: The smallest allowable length L of the bearing plate is in.

A: Given data

Q: The tee shape shown is used as a short post to support a load of P = 1670 Ib. The load Pis applied…

A:

Q: F The shaft is loaded with two forces as shown and is fixed at A. The strength is defined as the…

A: The given problem involves analyzing the strength of a shaft subjected to two forces and determining…

Q: If the beam has a rectangular cross-section, then the shear-stress distribution will be parabolic.…

A: The stress which occurs in the beam due to internal shearing per unit area is known as shear stress.…

Q: The beam is made from two plastic pieces glued together at the seam A.  If it is subjected to the…

A: Answer: The vertical shear force resisted by the flange of the beam at the critical section is…

Q: The bars of the truss each have a cross-sectional area of 1.25 in². Determine the average normal…

A: General Guidance:The external force and couple moment acting on a body can be reduced to an…

Combined Loading

Any functioning component, such as machine parts, structural members, pressure vessels, and so on, are all under the influence of more than one force. When anybody is under the influence of more than one force such as shear forces, bending moments, axial forces, torsion, and so on, then such body is said to be under combined loading. A very practical example of combined loading is the crankshaft of an internal combustion engine (IC engine). The crankshaft of the IC engine is under high rpm, which is caused due to the torsional forces. Due to the presence of piston, counterbalances, and internal imbalances, the crankshaft experiences lateral forces and due to the rise in temperature, the crankshaft undergoes thermal expansion, which pulls the crankshaft along the axial direction and lateral direction. The presence of unbalanced loads along the periphery of the crankshaft also induces a bending moment.