The theoretical and measured unit weight of mix is a Marshall specimen prepared for bituminous concrete with a bitumen content of 6 per cent by weight of total mix are 2.4 g/cm³ and 2.2 g/cm³ respectively. The specific gravity of bitumen is 1.05. The present voids in a mineral aggregate filled with bitumen (VFB) are (upto one decimal place)

The theoretical and measured unit weight of mix is a Marshall specimen prepared for bituminous concrete with a bitumen content of 6 per cent by weight of total mix are 2.4 g/cm³ and 2.2 g/cm³ respectively. The specific gravity of bitumen is 1.05. The present voids in a mineral aggregate filled with bitumen (VFB) are (upto one decimal place)

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

FOLLOW THE STEPS PLS AND ANSWER SAMPLE 1 USING VOLUME METHOD
The bulk unit weight of the dry-rodded aggregate inside a rigid container is 2800 kg/m3. 25 percent of the volume is occupied by the voids. What is the bulk specific gravity of the aggregate?
Highway materials,
Analysis of Fine AggregatesFill in the table:
I want the solution in less than 15 minutes
VFB=??
A concrete mix required for construction of an industrial building. Cement is PKC32,5. Specific gravity of cement is 31.5 kg/dm3. Vibrator will be used during the placement of concrete. The grading analysis of bulk aggregate as follows. Specific gravities and bulk density of aggregates as follows: :2.60 kg/dm3 Coarse Aggregate :2.65 kg/dm³ :2.72 kg/dm 1.30 kg/dm3 1.70 kg/dm3 1.55 kg/dm3 Sand Pebble Target strength has been desired as 20 + 5 = 25 MPa Workability of the resulting concrete will be Plastic Minimum amount cement will be 350 kg/m³ Grading of the bulk aggregate at the site: Sieve size (mm) 16 8 4 1 0.5 0.25 Cumulative Passing (%) 100 64.8 48.7 32.8 24.0 12.0 4,5 Design a concrete mix which is already solved by using Eprical Formulas according to ACI and TS and compate the results,
what is the requirement volume of fine aggregates (s.g. = 2..4) if the mass nedded for the concrete mix is 850 kg?
A Marshall specimen is prepared for bituminous concrete with a bitumen content of 5 percent by weight of total mix. The theoretical and the measured unit weights of the mix are 2.442 g/cm3 and 2.345 g/cm3, respectively. The bitumen has a specific gravity of 1.02. The percent voids in mineral aggregate filled with bitumen (VFB) are
In a typical concrete mix, the sand particles occupy roughly 30% of the concrete volume. If the bulk specific gravity of the sand is 2.607, how many pounds of sand are needed to make 7 yd³ of concrete (enough to fill a typical concrete transit truck). You can assume the unit weight of water is 62.27 lb/ft.
Q..
In a bituminous mix, bitumen content is 7% by weight of mix and specific gravity of bitumen is 1.01. If the bulk specific gravity of mix is 2.48, then the specific gravity of combined aggregate is (Take percentage air voids as 3.87%).