The tank on the truck shown in Figure 1 is completely filled with gasoline,which has a specific weight of 9asatine = 6.60 kN/m. The truck is decelerating at a rate of 3.05 m/s2. If the tank on the trailer is 6.1 m in length and if the pressure at the top rear end of the tank is atmospheric (p = 0 as shown in the figure), what is the pressure at the top front? If the tank is 1.83 m in height, what is the maximum pressure in the tank? p= 0 1.83 m -6.1 m- Figure 1: Truck with liquid tank.

The tank on the truck shown in Figure 1 is completely filled with gasoline,which has a specific weight of 9asatine = 6.60 kN/m. The truck is decelerating at a rate of 3.05 m/s2. If the tank on the trailer is 6.1 m in length and if the pressure at the top rear end of the tank is atmospheric (p = 0 as shown in the figure), what is the pressure at the top front? If the tank is 1.83 m in height, what is the maximum pressure in the tank? p= 0 1.83 m -6.1 m- Figure 1: Truck with liquid tank.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A semicircular, hinged gate separates two fluids on either side of a partition. Part (a) of the figure shows the geometry of the gate, and part (b) of the figure shows the whole system in side view. The radius of the gate (4 m) is equal to the height of the fluid on the right side of the gate (fluid 2), and the specific weight ratio of the fluids is γ2/γ1 = 1.5. At what height, h, will thegate just start to open?
Q4: A manometer of the shape shown in the figure has limb A filled with water and the limb B with oil with density 950 kg/m³. The area of the enlarged mouth portion is 50 time the area of the tube portion. If the pressure difference is 22 N/m² calculate the height h p2 p1 Ah water Oil Ah H=2h
The tank is filled with water. Suppose that h=4.0 m. Solve the problem using the integration method. Determine the resultant force acting on the trapezoidal plate C and determine the location of the center of pressure measured from the top of the tank.
A tidal barrage is in the shape of a quarter cylinder of radius r=16m, as shown in the picture above. If the barrage is 13m wide and holds back water of density 1014kg/m³ to its full height, what is the magnitude of the vertical force on the barrage? Assume that the atmospheric pressure is constant. Give your answer in Kilo Newtons to the nearest whole number. Use an acceleration due to gravity of g=9.81m/s²
You are being asked to determine the heights in tubes B and C (relative to z=0) given the following information: The specific weight of Air is Pair = 11.9N/m3 The specific weight of glycerine is Paiye = 12355N/m3 The specific weight of gasoline is Pgas = 6677N/m3 The gauge pressure at A is Pa = 1.6kPa The height of the tank of air is a = 1.7m The height of the tank of gasoline is y = 1.6m The height of the tank of glyercin is k = 0.95m A в с xm Air y m Gasoline k m Glycerin z = 0 As a HINT, you do not need to know the specific elevations of the tubes B and C entering their respective fluids, but you do need to account for this. Input the height the fluid rises in B to 2 decimal places here: (in metres) Input the height the fluid rises in C to 2 decimal places here: (in metres)
A bicycle tire pump has a piston with area 0.44 inches squared. If a person exerts a force of 30 lb on the piston while inflating the tire, what pressure does this produce on the air in the pump? Give your answer in psi.
The figure below shows a container filled with a liquid of density p up to a height of 4R. The container is of unit width into the plane of the screen and AB is half a parabola with a height of kR and a base of R. Determine the magnitude and direction of the vertical component Fy of the hydrostatic force acting on the curved surface AB if k = 2, R = 0.5 m, p = 1000 kg/m³ and the gravitational acceleration g = 9.81 m/s². Note that Fy is positive if it acts upwards and is negative if it acts downwards. Geometric properties of a half-parabola are also given below. Fy= 1. [-6.7362, -6.3438 kN. 4R h ထမ 35 b Liquid Р X Half-Parabola BR KR A = 3bh 1xc=²bh³ |yxc=hb³ |yy,c=²7/531 2 h63
at the bottom of a container, which forms an angle A with the horizontal, is a cube of edge a, as shown in the figure, made of a material of density p. Determine the force with which the cube presses on the bottom, if a liquid of density p0 is poured into the container. The top edge of the cube is h from the surface of the liquid. There is no liquid between the bottom of the container and the cube. The atmospheric pressure is P and the acceleration of gravity g (neglect the thrust).
Consider two tanks filled with water. The first tank is 8 m high and is stationary, while the second tank is 2 m high and is moving upward with an acceleration of 5 m/s^2. Calculate the pressure of each tank at the bottom.
The flow of water from a container is controlled by a 5-ft-wide L-shaped gate hinged at point A, as shown in the figure. If it is desired that the gate open when the height of the water is 10 ft, determine the weight W of the counterweight to achieve this. Take d= 5 ft and H = 16 ft. Give your answer in lb and without decimals.
One end/side of the pipe is positioned on level (h1) and the other is tilted upward at a height h2.The pressure values of fluid within this pipe, both on level and up, are measured as P1 and P2.If the fluid flow is kept at constant speed,use Bernoulli’s principle to show that pressure of the fluid inside the pipe tilted upward, P2, is given by: P2=P1 -ρgh2
The submerged brick in the figure below is balanced by a 2.54 - kg mass on the beam scale. What is the specific weight of the brick, if it displaces 2.197 liters water? 2.54kg