The table shows a series of standard additions of Cu(II)to acidified tap water samples measured by anodic stripping voltammetry at a platinum electrode. The unknown and all standard additions were made up to the same final volume. 1. Plot absorbance as a function of the concentration of Cu (II) standard. Determine the equation of the line and the X intercept. Find the concentration of Cu(II) in the water.

Q: 1 2 3 TEST TUBE 4 5 Blank Unknown solution Volume 0.52 M Fe₂(SO4)3 1.00 mL 2.00 mL 3.00 mL 4.00 mL…

A:

Q: The voltammogram for 20.00 mL of solution that was 3.65 x 10-3M in Cd2+ gave a wave for that ion…

A: Given: Volume of solution=20 mL Concentration=3.65×10-3 M Limiting current=31.3 micro Ampere

Q: 1. Virtual Lab Question: A solution of 0.0040 M copper dithizone transmits 66 % of the light at a…

A:

Q: Calcium in a 100.0 mL sample of fuit juice was analyzed by an electrochemical method that gave a…

A: Any particular substance/compound's quantity either in moles or in mass existing into solution's…

Q: Questions 11 and 12 refer to the same set of absorbance readings that were taken on metal-EDTA…

A:

Q: An unknown amount of copper(II) ions produces a faradic current of 12.3 A on a normal pulse…

A:

Q: Calculate the [FeSCN2+] using volumes of stock solutions. Presume that all the SCN– ions react.…

A: The data given is,

Q: The concentration of Fe²+ in a sample is determined by measuring the absorbance of its complex with…

A: We would use formula of absorbance given as :  A = ECl  where, E is molar absorptivity which depends…

Q: A solution in part C initially contains (4.2100x10^-4) molar SCN¯ and (3.1700x10^-3) molar Fe3+.…

A:

Q: A colored solution of concentration 0.0248 mol/L has an absorbance of 0.353. What is the…

A: The Beer-Lambert’s law, the absorbance (A) is directly proportional to the concentration (c) of the…

Q: We can determine the copper(II) ion content of a sample using spectrophotometry. The following data…

A: Absorbance is the amount of light absorbed by a substance. The Beer-Lamberts law states that the…

Q: The total volume must be close to 15.00 mL. Record the equilibrium concentrations and absorbances…

A: Sample A: Volume of Fe3+ used = Final volume-Initial volume=(19.53-12.38) mL=7.15 mLmillimoles of…

Q: To determine copper in a metallic alloy, 1.245 g of an alloy sample is dissolved in a 1: 2 mixture…

A: The molar absorptivity is determined by substituting 0.505 for A, 750 ppm for c, 1cm for l in…

Q: How to calculate the concentration of the two salts?

A: The objective of this question is to determine the concentration of two metal salts, Co(NO3)2 and…

Q: The absorbable of a solution is measured to be 0.806. If the path of the curvette is 1.07 cm, and…

A:

Q: A standard iron solution was prepared by dissolving 0.0140 g of pure iron in acid then transferring…

A:

Q: 1. Virtual Lab Questic particular waveleng absorptivity? What same conditions?

A: Absorbance = -Log [Transmittance]   Transmittance = 66 % = 66100 = 0.66   Absorbance = -Log0.66 =…

Q: A solution in part C initially contains (4.1000x10^-4) molar SCN¯ and (1.180x10^-1) molar Fe3+. This…

A: Given that: absorbance = 5.150×10-1  initial concentration of Fe3+ = 1.180×10-1 M initial…

Q: You wish to measure the iron content of the well water on the new property you are about to buy. You…

A: Interpretation - To calculate the concentration of iron in the well water is to be explained.

Q: Determination of the concentration of Zn(II) in a sample of river water was carried out by the…

A:

Q: Q/ If the intensity of the transmitted ray is equal to 0.12 of the intensity of the incident ray on…

A: Given that -  Intensity of transmitted ray  = 0.12  Thickness = 2 cm  Molar absorbance coefficient =…

Q: 5. A solution of certain dye has a calibration graph shown below when measured at 425 nm in 1.00cm…

A: Answer Using the Beer's lambert law The dye concentration at absorbance of 0.733M The equation of…

Q: Beaker 1 2 3 4 [FeSCN²+] (copy this from your prelab calculations) 1.6x10 1.2x10" M 8x105M 4x10 "M…

A: The best fit line equation shows the relation between the x-axis and y-axis quantities. This…

Q: You wish to measure the iron content of the well water on the new property you are about to buy. You…

A: data for  reference standard Fe3+ solution V1 = 14ml.  V2 = 60ml. M1 =5.74×10−4 M   , M2 =? path…

Q: The table shows a series of standard additions of Cu(II)to acidified tap water samples measured by…

A: The experiment involves the anodic stripping voltammetry at a platinum electrode.

Q: A solution in part C initially contains (4.0300x10^-4) molar SCN¯ and (2.880x10^-3) molar Fe3+. This…

A: We have to calculate the equilibrium constant.

Q: Roberta decided to find out the content of nickel (Ni) in a sample. She dissolved the 0.0882 g…

A: Given: Volume of solution = 250 mL = 0.250 L   Mass of Nickel sample = 0.0882 g Absorbance of…

Q: where 3, You are trying to find the equilibrium constant for the reaction A*(aq)+ B(aq) AB(aq) the…

A: Equilibrium is a condition at which the concentrations of reactants as well as products remains…

Q: A solution in part C initially contains (4.06x10^-4) molar SCN and (2.960x10^-3) molar Fe3+. This…

A: Given the initial concentration values of the reactants: [SCN-(aq)]i = 4.06*10-4 M [Fe3+(aq)]i =…

Spectroanalytical Methods

Spectroanalytical methods measure the wavelength and intensity of radiations that are either emitted or absorbed by a molecular or atomic species. These methods are useful for evaluating the electronic or atomic arrangement of the molecules of a given analyte.