The table gives data for open circuit and short circuit tests on a 6 pole, 440 V, 50 Hz, 3 phase star connected alternator. The effective ohmic resistance between any two terminals of the armature is 0.3 ohm. Field current (A) 2 4678 10 12 14 oC Vitage (V) 156 288 396 440 474 530 568 592 S.C current 11 22 34 40 46 57 69 80 Find the regulation at full load current of 40 A at 0.8 power factor lagging, using emf method and mmf method.

The table gives data for open circuit and short circuit tests on a 6 pole, 440 V, 50 Hz, 3 phase star connected alternator. The effective ohmic resistance between any two terminals of the armature is 0.3 ohm. Field current (A) 2 4678 10 12 14 oC Vitage (V) 156 288 396 440 474 530 568 592 S.C current 11 22 34 40 46 57 69 80 Find the regulation at full load current of 40 A at 0.8 power factor lagging, using emf method and mmf method.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

54. An RLC series circuit connected to a 110-volt and 50-cycle AC source, contains the following series resistances and reactances: R1=10 ohm, R2= 15, XL1=20 ohms, XL2=25 ohms, XC= 40 ohms. Find the following a. Equivalent reactance b. Total impedance c. Voltage drop across the capacitor
Q2: A Three Phase alternator has the following data: 2500 kva,3000v, star connected ,0.8 lagging power factor, armature resistance is 0.15 ohm/phase. The field winding takes 70 A at 140 V. The friction and windage losses is 20 kw and core losses are 35 kw. Determine the full load efficieney of alternator.
(4) For f = 60 Hz, V=120 v-rms and number of turns N = 500. Find rms flux linkages of the coil. (a) 5.3222x10 Wb (b) 4.2824x10 Wb (c) 6.3662x10 Wb (d) 7.3552x10 W b
Q4 A 11 kV, 500 MVA alternator is connected to a slow C.B. through a bus-bar. Determine the three ratings of the C.B, the average RRRV, and the oscillation frequency knowing that it reaches the peak re-striking voltage with 100 µs time.
56. A single phase thyristor adjust line spacing converter with a resistive load is shown below: V₂ = V sinest SCR ER R V₂ (B) 1.11 (D) 1.44 If the supply voltage is 230V (rms) at 50 Hz, calculate ripple factor for firing angle a-45" and R - 100 9. (A) I (C) 1.21
3. If the ratio of V/F has been kept constant and the observed value of hysteresis loss at rated frequency of 50 Hz is 18 W, the measured value of core losses is 35 W, Find the total core losses at the frequency of 60 Hz. 02:
Calculate the voltage per phase for a 1500 rpm, 4 pole alternator having a double layer winding with 16 turns per coil. The slots per pole phase are 8 and the coil span is 20 slots. The phase spread is 60o and the flux per pole is 25.8 milli webers.
The speed of a 100 MW alternator drops by 4% from no load to full load. (a) Find the speed regulation R of the alternator. (b) If frequency drops by 0.1 Hz, find change in power output.
A. And B.
A single phase induction motor is rated 5 hp, 75% power factor and 220 volts. What approximate size of capacitor is necessary to raise the power factor to about 98%. O 2.5 KVAR O 2.5 KVAR O 2 KVAR O 3.5 KVAR