The system shown in the figure has a weight of 1759 N whose weight acts at point G shown in the figure. Determine The Vertical Component Ay Acting On The Pin At A. Do not use negative numbers in the answer.

Q: Determine the magnitude of the clamping forces (in pounds) exerted on the nut along line aa when two…

A: Given: The force acting on handle, F = 64 lb

Q: 2. The bracket BCD is hinged at C and attached to a control cable at B. For the loading shown in…

A: To find : determine the tension in the cable and the reaction at C.

Q: Given the Horizontal wood member shown that weights 38 lbs/ft and supports three vertical loads F1 =…

A:

Q: 390 lb 1312 800 lb · ft - 8 ft- -4 ft- 3 ft 30°% BO 8 to 10. Draw the free-body diagram of member…

A:

Q: QUESTION 3 -50" B 50" A ♫ 11" 13" The bucket and its load have a combined weight of 4000 lb with…

A:

Q: The crane shown in the figure supports in G a weight of 150 lb (includes the log and the grapple…

A: For the given crane Weight = 150 lb  To draw  (a) FBD of entire crane  (b) FBD of part EFG and part…

Q: 5-Two ropes are tied with a load of mass 60 kg, as shown in the figure. Calculate the tension in AC…

A: W = 60 kgW = 60 * 9.81 = 588.6 NFind tension in AC and tension in BC

Q: Find the slack-side tension on pulley A in N.

A: Solving Part A , we assume that torque is transmitted undiminshed

Q: 1000 N 90 2000 N 90 1000 N 90 90 90° 130° 30 GG 12 m 12 m 12 m 1000 N

A:

Q: A shaft in equilibrium is shown below with dimensions as given in the table below: a b da dB dshaft…

A: Given data:

Q: The bent rod is supported at A, B, and C by smooth journal bearings as shown in (Eigure 1).

A:

Q: Q6. What is the stress concentration for normal stress due to bending at the critical location?…

A: Option - D => 1.4

Q: The beam shown is supported by a Roller at C and is fixed to the wall at A. The beam has an internal…

A:

Q: Replace the loading system by an equivalent resultant force and couple moment acting at point O.…

A: Here, given fores, F1=-140jF2=F2(-0.4i+0j-0.3k0.42+0.32)    =180(-0.8i-0.6k)    =-144i-108kResultant…

Q: The 1 inch diameter shaft is subjected to the loads shown. Draw the "loading diagram" showing the…

A: Diameter of shaft, d = 1 inch.There are 3 forces acting on the beam, 100 lb, 75lb, 80lb.

Q: A small winch is used to raise a load W=124 lb. Find the magnitude of force P that should be appli…

A: Given,  W= 124 lb

Q: NOTE: This is a multi-part question. Once an answer is submitted, you will be unable to return to…

A:

Buckling of columns

The column is described as a vertical member of the structure that carries an axial compressive load, and buckling is a lateral deformation of the column under the application of load.