Answered: The surface tension of water is 7 × 10²… | bartleby

Related questions

Question

100%

The surface tension of water is
7 x 10 ? N/m. Find the height at which water
rises in a capillary tube of glass having a bore
of uniform radius 0.2 mm. (Density of water =
1000 kg/m, accele-ration due to gravity
%3D
%3D
9.8 m/s³).

Expert Solution

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Blurred answer

Similar questions

What pressure (in N/m2) is exerted on the bottom of a gas tank that is 0.481 m wide by 0.814 m long and can hold 49.7 kg of gasoline when full? (Give only the pressure exerted by the gasoline.) | N/m²
volume flow rate and (b) the A M ra. The pressure difference between the two regions is 7.90 x10 Pa. What are (a) the A liquid of density B40 kg/m flows through a horizontal pipe that has a cross-sectional area of 2.90x 10 m in region A and a cross sectional area of 9.30 x 10 12. (a) Number Units Units
A certain hydraulic system is designed to exert a force 405 times as large as the one put into it. (a) What must be the ratio of the area of the slave cylinder to the area of the master cylinder? (b) What must be the ratio of their diameters? (c) By what factor is the distance through which the output force moves reduced relative to the distance through which the input force moves? Assume no losses to friction.
A U-tube open at both ends is partially filled with water (Figure (a)). Oil (p = 750 kg/m³) is then poured into the right arm and forms a column L = 4.53 cm high (Figure (b)). Shield Po Water Oil (a) Determine the difference h in the heights of the two liquid surfaces. (The density of water is 1.00 x 103 kg/m3.) cm (b) The right arm is then shielded from any air motion while air is blown across the top of the left arm until the surfaces of the two liquids are at the same height (Figure (c)). Determine the speed of the air being blown across the left arm. Assume the density of air is 1.29 kg/m. m/s
A uniform cross-sectional area U-tube is open to the atmosphere, is partially filled with mercury (density = 1.36 x104 g/cm3 ). Water is then poured into both arms. If the equilibrium configuration of the tube is as shown in Figure, with h2 = 1.00 cm, determine the value of h1.
A U-tube open at both ends is partially filled with water (Figure a). Oil having a density of 790 kg/m³ is then poured into the right arm and forms a column L = 5.18 cm high (Figure b). Shield Po FU h Water Oil a (a) Determine the difference h in the heights of the two liquid surfaces. cm (b) The right arm is then shielded from any air motion while air is blown across the top of the left arm until the surfaces of the two liquids are at the same height (Figure c). Determine the speed of the air being blown across the left arm. Take the density of air as 1.20 kg/m³. m/s
In an immersion measurement of a woman's density, she is found to have a mass of 63.0 kg in air and an apparent mass of 0.841 kg when completely submerged with lungs empty. (a) What mass of water (in kg) does she displace? (b) What is her volume (in m3)? (c) Calculate her density (in kg/m3). (d) If her lung capacity is 1.75 L, is she able to float without treading water with her lungs filled with air? (YES/NO)