The structure shown has a diameter of 40??. The length dimensions are ? = 525 ?? and ? = 110 ??. Using load magnitudes of ? = 900 ? and ? = 1600 ?, determine the stress state at point H.

Q: The two aluminum rods AB and AC support the vertical force of P= 15 kN. If the allowable stress for…

A: Vertical force ,P=15 KNAllowable stress=150MPaTo determine:Required diameter of rod AB,dABFBD:…

Q: Draw Mohr's circle for the state of stress defined by 01 = 80 MPa, o2 = -20 MPa and t12= 40 MPa. (1…

A: To draw mohr's circle for the state of stress

Q: The rigid beam is supported by a pin at A and aluminum wires BD and CE. If the beam displaced 3.4 mm…

A: Given data          If the beam displaced by…

Q: please see attached screen shot

A: The given radius of the hole is r=0.5.Here, the value of 2r/d = 2(0.5)/5 = 1/5 = 0.2The stress…

Q: Bar (1) has a cross-sectional area of 0.75 in.². If the stress in bar (1) must be limited to 39 ksi,…

A: Correct answer: (b) 17.55 kips

Q: Determine the normal stress perpendicular to plane AB and the shear stress parallel to plane AB

A: Determine the normal stress perpendicular to plane AB and the shear stress parallel to plane AB.

Q: The state of stress at a point in a member is shown on the element below. If: 0x = 9 MPa Oy=-14 MPa…

A:

Q: The boom is supported by the winch cable that has an allowable normal stress of allow = 24 ksi. It…

A:

Q: Question 3: The cast iron of a small press has a cross section as shown. For Q = 16-kips, determine:…

A:

Q: A column is made of the two materials side by side as shown. Each material carries a portion of the…

A:

Q: The 1.06-in.-diameter rod in (Figure 1) is subjected to the loads shown. 9 in. 200 lb 300 lb 3 in.…

A:

Q: The 10-mm-diameter steel bolt in (Figure 1) is surrounded by a bronze sleeve. The outer diameter of…

A:

Combined Loading

Any functioning component, such as machine parts, structural members, pressure vessels, and so on, are all under the influence of more than one force. When anybody is under the influence of more than one force such as shear forces, bending moments, axial forces, torsion, and so on, then such body is said to be under combined loading. A very practical example of combined loading is the crankshaft of an internal combustion engine (IC engine). The crankshaft of the IC engine is under high rpm, which is caused due to the torsional forces. Due to the presence of piston, counterbalances, and internal imbalances, the crankshaft experiences lateral forces and due to the rise in temperature, the crankshaft undergoes thermal expansion, which pulls the crankshaft along the axial direction and lateral direction. The presence of unbalanced loads along the periphery of the crankshaft also induces a bending moment.