The steel rod is supported by an aluminum plate of 8 mm thickness. Force P pulls down the rod through the 12 mm hole in the aluminum plate. Based on the design criteria that the maximum allowable shear stress in aluminum to be 70 MPa and in steel is 18 MPa, what is the limiting value for P in kN? Round to the nearest tenth. 10 mm T 12 mm -- -40 mm- P 8 mm

Q: 1.Consider the magnetic core below.All dimensions are shown on the figure. The core is made up of…

A:

Q: A ferromagnetic core with a depth of 5 cm and relative permeability of 1550 is shown in Figure 1.…

A:

Q: A magnetic core with an air gap is shown below. For a relative permeability is 3500, and the space…

A: Transformer question

Q: 11. There is 900 mA of current through a wire with 40 turns. What is the reluctance of the circuit…

A:

Q: property of a material which opposes the production magnetic flux in it is known

A: All material does. Not allow to pass the flux through it without any oppose

Q: A flux of 0.0016 Wb flows in a silicon sheet steel coil/core. The arrangement appears as shown below…

A:

Q: An air-cored choke is designed to have an inductance of 20H when operating at a flux density of I…

A: We have been given an air-cored choke having,   Inductance (L) = 20 H Flux density = 1 Wb/m2…

Q: A ferromagnetic core with a depth of 5 cm and relative permeability of 1550 is shown in Figure 1.…

A: Given information about the magnetic core: Air gap length Lair=0.67 cm. Due to fringing the…