The state plane stress at a point is represented by the stress element below. Determine the stresses acting on an element oriented 30 degree counterclockwise respect to the original element. Calculate the shearing stress at the xy-face 60 MPa

Q: Consider a certain critical point in a stress element. On a vertical plane, the compressive stress…

A: Given Normal stress on the horizontal plane σx=0. Compressive stress is σy=115 Mpa. Shear stress is…

Q: The thin bar is subjected to an increase in temperature along its axis. Determine the end B of the…

A:

Q: When an axial load is applied to the ends of the bar shown in the figure, the total elongation of…

A:

Q: The rectangular plate is subjected to force P that causes elongation in the horizontal direction and…

A:

Q: 3. The plane stress is shown on the element. Use Mohr's circle. 1) Determine the principal stresses…

A:

Q: 1. The plate below is attached to the vertical surface AB. Its top and bottom surfaces slide…

A:

Q: - Change gy from 100 MPa to 139.10 MPa - Determine the equivalent state of stress on an element at…

A: Given:- To find:- Equivalent state of stress on an element oriented at 30o clockwise Concept:- The…

Q: Mohr's circle is shown for a point in a physical object that is subjected to plane stress. Each grid…

A:

Q: mine the maximum shear stress for the 7.. 3₁ == 0 MPa Txy=-31 Ox=37

A:

Q: 3. The plane stress is shown on the element. Use Mohr's circle. 1) Determine the principal stresses…

A: Finding out principal planes and stresses.

Q: 5. The state of stress at a point in a member is shown on the element. Determine the stress…

A:

Q: Q-2-dimensional fluid elements is subjected to hydrostatic pressure 20 MPa. The maximum shear stress…

A: 2-dimensional fluid elements- Hydrostatic pressure P=20 MPa, Maximum shear stress=?

Q: 0=-80MPA o=20MPA 0=20MPA 0=-80MPA

A:

Members with compression and bending

Compression members are structural elements that carry compressive axial force. They are the vertical members of a building that support beams and their design, which is governed by buckling and strength. Columns are known as struct or compression members, which are subjected to compressive forces. These members provide stiffness to the building and avoid any imperfection regarding the transfer of axial load. For instance, webs in a truss, braces in a framed structure, tiers, and so on.