The standard length of a tape is 100m having a weight of 2kg with the standard temperature of 20°C and standard pull of 5kg. The young modulus of elasticity of the tape is 200GPA, cross sectional area is 6.05mm? and the coefficient of linear expansion is 0.0000116/"C. a. Determine the normal tension of the tape in Newton. b. Assuming the tape supported all throughout its length, determine the adjusted length in meter of the tape using the normal tension. Note! The normal tension of a tape is the applied tension which will cause the effects of pull and sag to neutralize each other.

Q: 20mm Square plate is subjected normal stresses as illustrated. Modulus of Elasticity, E = 1081 MPa…

A:

Q: 20mm Square plate is subjected normal stresses as illustrated. Modulus of Elasticity, E = 704 MPa…

A:

Q: The piece of plastic is originally rectangular. Calculate the shear strain Yxy at corners A and B if…

A: For small angles.

Q: A rigid horizontal slab is attached to two identical copper rods. There is a gap, A = 0.18 mm…

A: Given data,

Q: The strain components & & and Yxy are given for a point in a body subjected to plane strain.…

A:

Q: A vibration isolation support consists of a rod A of radius R₁ and a tube B of inner radius R₂…

A: G = 10.93 MPaP = 13 kN or 13000 N

Q: 7. A cylindrical steel bar is subjected to repeated compression-tension stress cycling along its…

A:

Q: The rigid beam is supported by three 25-mm diameter A-36 steel rods. If the beam supports the force…

A:

Q: 1.3 Two solid cylindrical rods AB and BC are welded together at B and loaded as shown. Determine the…

A: Determine the magnitude of the force P for which the tensile stress in rod AB has the same magnitude…

Q: The hollow shaft shown is made of a steel that is assumed to be elastoplastic with Ty= 145 MPa and…

A: Given,Yield shear stress,  =  145 MPaModulus of rigidity, G = 77.2 GPaLength, L = 6m or 6000 mm

Q: The beam shown in Fig QB1 is made from aluminium tube of rectangular cross-section having a vertical…

A: As per bartleby guidelines, only 1st 3 parts among multiple parts, need to be solved. For rest of…

Q: A cantilever beam is made by using cross-section as shown in figure. A hogging bending moment of 0.4…

A:

Q: A compound bar consists of a circular rod of steel of diameter 25 mm, rigidily fitted into a copper…

A: Given data, Steel rod diameter = 25 mmCopper inner diameter = 25 mmCopper outer diameter = 25+5= 30…

Q: Wire BC has a diameter of 0.10 in. And its material has the stress-strain characteristics shown in…

A: Shear stress is the amount of loading which gets sheared in the beam or any structural element by…

Q: TI The piece of plastic is originally rectangular. Calculate the shear strain Yxy at corners A and B…

A: For small angles.

Dependence on mechanical properties

The mechanical properties of materials are those structures that include the reaction to the load used. Metal switching features determine the scope of the usefulness of the content and establish the expected service life. Machine structures are also used to help distinguish and identify material objects. The most common mechanical properties considered are strength, ductility, stiffness, impact resistance, and resilience to fractures.