The spanner shown is used to rotate a shaft. A pin fits in a hole at A, while a flat, frictionless surface rests agains the shaft at B. If a 300-N force P is exerted on the spanner at D, find (a) the reaction at B, (b) the component of the reaction at A in a direction perpendicular to AC. P D B 75 mm 375 mm-

Q: 2. A 12-ft wooden beam weighting 120 lb is supported by a pin and a bracket a A and by cable BC.…

A:

Q: B 4 2 A 200 KN 100 KN 7A.Find the reaction of the placement of the skeleton next to 7B.Determine the…

A: The support reactions can be calculated by considering the summation of vertical forces to be zero…

Q: The overhanging beam is supported by a pin at A and the two-force strut BC Determine the horizontal…

A:

Q: Based on the attached figure: (a) Determine the horizontal and vertical components of reaction at A.…

A:

Q: Question 6 Neglecting the weights of the bar and the pulley and assuming the weight of the ball B to…

A:

Q: The spanner shown is used to rotate a shaft. A pin fits in a hole at A, while a flat, frictionless…

A: The objective of this problem is to find the component of the reaction at A in a direction…

Q: The L-shaped body is supported by a roller at B and a frictionless pin at A. The body supports a…

A:

Q: Question 3 (Type B): The 50 N force F is parallel to the y axis. Determine the components of the…

A: The force F is

Q: 40cm E 45cm-30cm- 750N Knowing that the pulley at D has a radius of 12cm, determine the components…

A: According to the given datar=12cmWe need to findreactions at point-B and E

Q: Solve for all reactions at A and B

A: The free-body diagram of the given truss system can be drawn as below, Here, RB is the normal…

Q: ray for the paper supply of a photocopy machine is shown. The tray is supported by a single hinge at…

A: Given-Information:- Weight, W = 14 ND = 190 mm  To-Determine:- Reactions at point B

Q: 5. The bent rod of negligible weight is supported by a ball-and-socket joint at A and a single…

A:

Q: Suppose P = 2500 lb. From the frame below, determine the magnitude and direction of the vertical and…

A:

Q: 1.5 m B 1.5 m I m 2.5 m 3 m -- 1.5 1.5 m-1 mª| 3 m

A: given data: w=900N/m total weight=900*3=2700N

Q: 2. A 200-mm lever and a 240-mm pulley are welded to the axel BE that is supported by bearings at C…

A: Taking moment about C∑Mz=0720200-T120=0T=720×200120T=1200Nso the tension in cord is 1200N

Q: center at G. Determine the force in the hydraulic cylinder AB (positive if in tension, negative if…

A:

Forming and Shaping

Metal forming is a category of metalworking process through which the material can be given the desired shape and size by subjecting it to plastic deformation, where the component undergoes bulk deformation process upon application of loads. Unlike the shearing and machining process, the material does not undergo up to a failure point as indicated in the stress-strain curve. Hence, the stresses induced during the forming process are greater than yield strength but less than the failure strength of the material. The process does not lead to the loss of material, so it can be said to be an economical process. During forming, the material is subjected to tensile forces, compressive forces, bending, and shearing loading conditions. The material should possess the property of ductility to undergo the forming process.