The simply supported beam below is subject to a single point-load at 6 meters from the hinge support at the left side. 4 kN 6 m 4 m Which of the following best describes the magnitude of the shear force vs. position along the beam between the applied force and the roller support? O zero - no shear force present constant - shear force does not vary with position along the beam shear force increases linearly towards the roller-supported beam end shear force increases parabolically towards the roller-supported beam end

Q: 4. Draw Shear Force and Bending Moment Diagram 5 kN A 2 kNm 4 kN/m C D LLI E

A: Note:- As per guidelines we are only supposed to answer first question.

Q: PL. (kN) m.Im wdl (kN/m) wll (kN/m) A 3m B TWIT 3m 6m D

A: Draw the ILD for shear at point C by using Muller Breslau principle( provide unit separation between…

Q: Solve for the following internal forces occurring on the beam loaded as shown below. a. Moment at B…

A: Moment at Support A, MA = 0 KN-m => -12(26)(6)(7.6+236) + RD(10.6) - (15.9)(3.6) => RD =…

Q: For the loading on the beam calculate the maximum normal stress due to bending on a transverse…

A: Beam size = 100mm × 200mm  Determine the maximum normal stress due to bending at section C.

Q: Solve and determine the absolute maximum shear in the beamdue to the loading shown.

A:

Q: etermine the maximum shear ress in the T-beam at the critical ection where the internal shear rce is…

A:

Q: B D A E 6ft -6 ft FIG. PS.8 the beam shown, calculate (a) the maximum bending stress; ress at a…

A:

Q: Solve ALL FORCES and DRAW THE SHEAR FORCE (V-D) AND BENDING MOMENT (M-D) COMPLETELY of the following…

A: Support Reactions :  RA + RB = 2×12×4.5×5 = 22.5 kN ........(1)Taking moment about A,RB×9 -…

Q: The beam is made from four plates and subjected to a shear force of V = 15 kN

A:

Q: 2. The frame is subjected to the load of 15 kN which acts on member ABD at D. Determine the required…

A: For calculating the diameter of pins we must calculate the forces acting on those points. The forces…

Q: Q3. Draw the shear and bending for the following: 75 kN m- 90 kN 80 kN·m 100 A kN-m 6 m 75 kN

A: Draw the shear force and bending moment diagram. Note:- As per the company guidelines we are allowed…

Q: F12-3. Determine the absolute maximum shear stress developed in the beam. 30 kN 15 kN 1s mm -300 mm-…

A: Consider the figure,

Q: 1-67 The beam is supported by a pin at A and a short link BC. If P = 15 kN, determine the average…

A:

British Gravitational Bg System Of Units

Measuring is the comparison of a particular physical quantity with its reference value. A unit is a fixed physical quantity. The length is a physical quantity. A physical quantity is the product of a unit and the numerical value we need to compare with.