The shown distribution network is to supply two factories A & B with load curves indicated. Assume that both factories have a lagging power factor of 0.8 . Select the required sizes of transformers for both factories such that in the case of a failure in one transformer the overload on the remaining ones should not exceed 15%. Select the required sizes of fuses to be installed at both sides of transformers. Calculate the annual energy losses in transformers of factory A. Assuming that transformers are in operation continuously . Select the required size of the 11KV. XLPE cables for the distribution network , if cables are to be laid direct in ground with maximum ground temperature of 30° C. Calculate the annual energy losses in cables of section SA .

The shown distribution network is to supply two factories A & B with load curves indicated. Assume that both factories have a lagging power factor of 0.8 . Select the required sizes of transformers for both factories such that in the case of a failure in one transformer the overload on the remaining ones should not exceed 15%. Select the required sizes of fuses to be installed at both sides of transformers. Calculate the annual energy losses in transformers of factory A. Assuming that transformers are in operation continuously . Select the required size of the 11KV. XLPE cables for the distribution network , if cables are to be laid direct in ground with maximum ground temperature of 30° C. Calculate the annual energy losses in cables of section SA .

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

If the values of real power and reactive power is specified for a bus, then it is called as PQ bus. Select one: True False
Explain how power factor and system efficiency are related
Discuss the significance of power factor in power distribution and how power factor correction can improve system efficiency.
A power station is to supply four (4) regions of loads whose peak values are 10 MW, 7.5 MW, 8 MW, and 12 MW respectively. The diversity factor of the loads in the station is 1.5 and average annual load factor is 65%. Calculate the maximum demand on the station and the annual energy supplied from the station.
In the case of reactive power compensation in a low voltage distribution network and increasing the power factor to cosQ2 = 0.92 as a result of compensation while cosQ1 = 0.75, which of the following expresses the change in apparent power transmitted from the line a) increase by 22.66% b) decrease by 22.66% c) increase by 18.47% d) increase by 15.00% e) decrease by 18.47%
2. a) Explain the terms load factor and diversity factor. b) Discuss the advantages of interconnected grid system. c) A generating station is to supply four regions of load whose peak loads are 10 MW, 5 MW, 8 MW and 7 MW. The diversity factor at the station is 1-5 and the average annual load factor is 60%. Calculate: (i) the maximum demand on the station, (ii) annual energy supplied by the station and (iii) suggest the installed capacity and the number of units.
Enlist the power quality issues for renewable energy integration
A network is supplied by a 120 V rms, 60-Hz voltage source. An ammeter and a wattmeter indicate that 12 A rms is drawn from the source and 800 W are consumed by the network. Determine: a. The network power factor b. The network phase angle c. The network impedance d. The equivalent resistance and reactance of the network
1- define A. Microgrid B. Distributed generation C. Discuss the advantages and disadvantages of microgrid systems over conventional power systems
2. Discuss any two methods for power factor improvement
Discuss the challenges and solutions related to renewable energy integration into existing power systems.
Q2// Explain the terms, connected load, load factor, plant use factor, diversity factor.