The rigid rod AB is attached to a hinge at A and to two springs, each of constant k. If h = 16 in., d = 12 in., and if the weight of the block at B is 0.5 lb, determine the range of values of k for which the equilibrium of rod AB is stable in the position shown. Each spring can act in either tension or compression.

Q: Q3. Determine the tension developed in each cord required for equilibrium of the cylinders. F T- 200…

A:

Q: For the linkage shown, determine the force Q required for equilibrium when I = 18 in., M = 600…

A: The data given is, The moment on the member, M = 600 Ib.in The angle of inclination, θ= 70° Length…

Q: A force P with a magnitude of 240 N is applied to end E of cable CDE , which passes under pulley D…

A: Draw the free-body diagram of the mechanism.

Q: The upper end of the bar of a problem is now leaned against a non vertical wall. Determine the…

A:

Q: Determine the largest couple C

A: Given:  cylinder and the block are connected by a horizontal cord To determine:  The largest couple…

Q: 3-3. If the mass of the girder is 3 Mg and its center of mass is located at point G, determine the…

A:

Q: Cable AB passes over the small ideal pulley C without a change in its tension. What length of cable…

A:

Q: Determine the components of reaction at the ball-and-socket joint A and the tension in the…

A: please refer handwritten solution

Q: Member AB is supported by a cable BC and at A by a square rod which fits loosely through the square…

A:

Q: Q3. The lamp has a weight of ( 40 N) and is supported by the six cords connected together as shown.…

A: Given Data W=40 N

Q: Determine the force in cables AB, AC, CD, CE, and CF needed to support the 500-lb crate. Complete…

A: The weight of crate is

Q: The rigid rod AB is attached to a hinge at A and to two springs, each of constant k. If h= 450 mm,…

A: Given- h= 450 mm=0.45 m d= 300 mm= 0.3 m m=200 kg Taking the free body diagram of the rod AB,…

Q: Member AB is supported by BC and at A by a single journal bearing with a square shaft. Determine the…

A: Free body diagram:Position vector:System A will move up and down, therefore there won't be any…

Q: Consider the following system in static equilibrium. Force vector Facts at a distance" from the pin…

A: (a) Draw the free-body diagram of bar.

Q: Determine the tension developed in wire CD required for equilibrium of the 37 lb cylinder E and the…

A: Given  Weight, WE = 37 lb              WF = 46 lb Find   Tension in CD, TCD

Chemical and Phase Equilibrium

Phase diagrams or equilibrium phase diagrams are the graphical representations that show the phase transformations of the constituting elements with respect to the pressure, temperature, and compositions. The diagrams show the conditions that limit the different phases, namely solid, liquid, and gas. The diagram can also be utilized to verify the relations between the state variables. Most of the phase diagrams are temperature-pressure phase diagrams, with the variable parameter as the composition. Usually other variables such as solubility and pressure parameters are not indicated in the phase diagram. For a one-component system (unary phase diagram), the phase diagram is generally a function of temperature and pressure as the state variables, or temperature and volume. However, for a binary system (two-phase) having two components, the phase diagram is a function of temperature and composition as the state variables only. Coexisting of the different phases of the constituting elements is indicated in the phase diagram. A ternary phase diagram can be characterized by consisting of three phases in equilibrium.