The rigid beam BC is supported by rods (1) and (2). The cross-sectional area of rod (1) is 9 mm². The cross-sectional area of rod (2) is 17 m². For a uniformly distributed load of w= 2.8 kN/m, determine the length a so that the normal stress is the same in each rod. ssume L = 5.30 m. A (1) B nswer: a = L a D (2) m

The rigid beam BC is supported by rods (1) and (2). The cross-sectional area of rod (1) is 9 mm². The cross-sectional area of rod (2) is 17 m². For a uniformly distributed load of w= 2.8 kN/m, determine the length a so that the normal stress is the same in each rod. ssume L = 5.30 m. A (1) B nswer: a = L a D (2) m

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Show Free Body Diagram Show complete solution anf clear hand writing
8
Show complete solution
Mechanics of deformable bodies. Two decimal places.
Given this topic: "Implementation of GIS and related tools for spatial and temporal monitoring of pavement, bridge, safety and congestion attributes for a state highway network" a) what are the importance of monitoring those highway attributes? b) What could be the objectives of this topic? b) What are the relevance of GIS in transportation engineering,
ANSWER THE PROBLEM GIVE WHAT IS ASKED, SHOW YOUR SOLUTION, AND BOX THE FINAL ANSWERS. WRITE IT ON A CLEAN PAPER CLEARLY. I WILL GIVE THE FEEDBACK RATING AS POSSIBLE, YOU CAN ANSWER IT. THANK YOU
Thumbs-up will be given. Write the complete solutions legibly. No long explanation needed. Solve in 3 decimal places. Box the final answer.
Why clamp handles are used?
STRENGTH OF MATERIALS. Please show the complete solutions. Rate will be given. Answer in 3 decimal places! The compound shaft consists of solid steel and bronze shafts and hollow aluminum shaft (D= 2.25" and d=0.90''). It is subjected to two torques as shown in the figure. The moduli of rigidity for steel, aluminum, and bronze are 12x106 psi, 4x106 psi, and 6x106 psi, respectively. Determine the shearing stress developed in each material. Also, calculate the angle of twist incurred by the aluminum shaft.
For the following problem please show intermediate steps including free body diagrams, equation used, problem setup etc. so that your approach can be followed. Finally please put the answer in a box with the appropriate unit.
- GET THE GIVEN, WHAT IS ASKED, AND THE ANSWER. - MAKE A PROPER FREE BODY DIAGRAM. (IT DOES HAVE THE GREATER POINTS IN THIS ACTIVITY) - YOUR SUB ANSWERS MUST BE IN 6 DECIMAL PLACES. - YOUR FINAL ANSWER MUST BE IN 4 DECIMAL PLACES. - TELL THE DIRECTION AND WHETHER IT IS TENSILE OR COMPRESSION. - WRITE YOUR SOLUTION PROPERLY (EASY TO UNDERSTAND). - PLEASE BASE YOUR SOLUTIONS ON THE SAMPLE PROBLEM I'VE GIVEN.
STRENGTH OF MATERIALS. Please show the complete solutions. Rate will be given. Answer in 3 decimal places! Answer ASAP!