The rigid bar in (Figure 1) is pinned at A and supported by two aluminum rods, each having a diameter of 1.5 in., a modulus of elasticity E-10(10³) ksi, and yield stress of (ay)=44 ksi Figure 1 of 1 B J E 1.5 ft 1.5 ft 20 kip 1ft 2 ft 1 ft Y Part A If the bar is initially vertical, determine the angle of tilt of the bar when the 20 kip load is applied. Express your answer to three significant figures and include appropriate units. HA → ? Value Units Submit Provide Feedback Request Answer

Q: A solid copper bar of circular cross sectionhas length L =1.25 m and shear modulus of elasticityG =…

A: Shaft is designed on the basis of following two criteria:- Strength Criteria According to Strength…

Q: Observe the figure that shows the assembly of the ACD arm, suspended by a bearing in C coupled to a…

A:

Q: The figure shows a cantilever of length L = 4 m consisting of steel angles size of 100 x 100 x 12 mm…

A:

Q: Useful equations; o = E A 1. The steel shaft carries the axial loads as shown in the figure below.…

A: Given axial load action on stepped shaft  as shown below

Q: Calculate the increase in stress for each segment of the compound bar shown in the figure if the…

A:

Q: K 3m 3m * * P D 6m B E 6m 9m The truss ABCDEF is pinned at A and F. What is the force in bar BE when…

A:

Q: The rigid beam BC shown in the figure is supported by rods (1) and (2) that have cross-sectional…

A: Given:A1=175 mm2A2=300 mm2w=16 KN/mL=2.8 ma=1.7 m

Q: The steel member shown below has a diameter of 69 mm, modulus of elasticity of E=200 GPa, and is…

A: Draw FBD

Q: The rigid bar BC shown in the figure is subjected to an external load Fapplied and is supported b…

A: Given cross section is given below   We will calculate the x in the following mannerx =∑area×…

Q: If the maximum stress both in tension and compression is not to exceed 120 Mpa, determine the…

A: Step 1: Step 2: Step 3: Step 4:

Q: This is a multi-part question. Once an answer is submitted, L- P

A: Given-Information:- Length, L = 4 m Angle size 100×100×12 mmP =3000 N a =1.75 m =1750 mmW =1000 N/m…

Q: (a) the deformation of segment (2). (b) the deflection of joint D with respect to the fixed support…

A:

Q: The bell-crank mechanism is in equilibrium for an applied load of P = 16 kN. Assume that a = 250 mm,…

A:

Q: etermined the maximum normal stress experience by the entire axial member and determine the section,…

A:

Axial Load

When a bar of the uniform cross-section is acted by a load, such that the load acts along the longitudinal axis of the bar, such kinds of loadings are known as axial loadings. In general terms, a load is an external force acting on a component. An axial load acts perpendicular to the geometric cross-section of the component. Based on the direction of the application of the load, an axial load can be tensile or compressive. The analysis of bodies under the action of axial loads is generally studied under the branch of mechanics, known as statics.