The rectangular loop of wire shown in the figure (Figure 1) has a mass of 0.12 g per centimeter of length and is pivoted about side ab on a frictionless axis. The current in the wire is 9.0 A in the direction Part A shown. Find the magnitude of the magnetic field parallel to the y-axis that will cause the loop to swing up until its plane makes an angle of 30.0 ° with the yz-plan Express your answer i teslas. B = T Submit Previous Answers Request Answer Figure < 1 of 1 > X Incorrect; Try Again; 6 attempts remaining • Part B 6.00 cm Provide Feedback 30.0 8.00 cm

The rectangular loop of wire shown in the figure (Figure 1) has a mass of 0.12 g per centimeter of length and is pivoted about side ab on a frictionless axis. The current in the wire is 9.0 A in the direction Part A shown. Find the magnitude of the magnetic field parallel to the y-axis that will cause the loop to swing up until its plane makes an angle of 30.0 ° with the yz-plan Express your answer i teslas. B = T Submit Previous Answers Request Answer Figure < 1 of 1 > X Incorrect; Try Again; 6 attempts remaining • Part B 6.00 cm Provide Feedback 30.0 8.00 cm

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

Find the magnitude and direction of the minimum magnetic field required to move the wire at constant speed.
In the figure below, point P is at a perpendicular distance a = 13 cm from one end of a straight wire of length L = 15 cm carrying current I = 6 A. (Note that the wire is not long, or infinite.) What are the magnitude and direction of the magnetic field at P? For direction, you can say into or out of the page.
I can't seem to figure out this what I missing from my calculation can you help me with this?
As shown in the figure below, a circular ring with a radius of a is folded along a line across the diameter so that the two semicircles are perpendicular. In the magnetic field, this ring was rotated at a constant angular velocity over time, as shown in the figure. The axis of rotation is an extension of the fold-off line and is perpendicular to the magnetic field. The resistance of the ring is R. (1) Give a qualitative explanation of what will happen. (2)Find the current flowing through the ring. (3)What torque should be applied to the ring to allow it to rotate at a constant angular speed? (4)What do you have to do to turn it N round? (5) What energy changes from ring to heat? (6) How much energy changes from ring to heat? * I'll be so thankful and satisfied to get answer just least 3 of 6 questions..
Needs Complete typed solution with 100% accuracy.
the tolerance is ±1 in the 3rd significant digit and box your final answer
A circular coil of current I=1A and area A= is placed flat on a table where the magnetic field B= 1T along the horizontal and to the right, Seen from above and looking down on the table, the current is flowing in a counter clockwise direction. Find the following2.1. Calculate the torque on the coil for N=12.2. What is the torque on the coil when the coil has turned by 30°2.3. What is the torque on the coil when the coil is perpendicular to the field lines?
B INSTRUCTION Solve the following problems. ANSWER ONLY TWO OUT OF THREE QUESTIONS. Show your complete solutions. NOT FOLLOWING OF INSTRUCTIONS will be a deduction of 10 POINTS from the total score. 1.A proton enters a magnetic tield of flux density 1.5 Wb/m² with a vetocity of 2.0 x 107 m/s at an angle of 30° with the field. Compute the force on the proton. 2.A steady current of 2 A in a coil of 400 turns causes a flux of 104 wb to link (pass through) the loops of the coil. Compute the average back emf induced in the coit it the current is stopped in 0.08 seconds. 3. A coil of 50 loops is pulled in 0.020 seconds from between the poles of a magnet, where its area intercepts a flux of 3.1 x 10-4 Wb, to a place where the intercepted flux is 0.10 x 10-4 Wb. Determine the average emf induced.
A straight wire of length 45 cm is moved an angle of 30° to a uniform magnetic field of 2.0 x 106 T with speed of 3.5 ms'. Calculate the induce e.m.f produced in the wire. If the wire is connected to circuit of resistance of 2.0 Q, determine the amount of charge will flow in the circuit. Suggest one way by which this amount of charge may be increased. With the help of a diagram, explain your answer.
Please solve part A & B
Please solve asap i'm studying for my test tomorrow and i need the answer
Two long wires a positioned as shown below -- one along the x direction and one along y direction. Each wire has a current of 10 A in the indicated directions and the top wire is 10 cm above the bottom wire. What is the angle of the B field exactly half-way between the two wires in degrees? We define to the right as 0 degrees, up as 90, left as 180, and down as 270. What is the magnitude of the magnetic field in μT to 3 significant digits?