The readings of the two instrument connected to a balanced three-phase load are 128 W and 56 W. When a resistor of about 25 ohms is added to each phase, the reading of the second instrument is reduced to zero. The power in the circuit before the resistors were added?

Q: Write the HDL gate-level hierarchical description of a four-bit adder–subtractor for unsigned binary…

A: Write the HDL gate-level hierarchical description of a four-bit adder–subtractor for unsigned binary…

Q: 3- phase power don't we need to multiply with 3? also Vt=13.1 KV, so shouldn't it be 13.1e3? in the…

A: The three-phase power can be calculated by the formulas shown below:…

Q: Question No.84 Three loads, each of resistance 50 Q are connected in delta to a 400 V, 3-phase…

A:

Q: a wye connected load as 480v applied to it what is the volatage drop across each phase?

A:

Q: Look at the photograph and answer the following questions: A) Ammeter A1 is measuring a. Line…

A: Ammeter to measure current . A1 is connected to line of the supply .  1) A1 measures line current .…

Q: Why cable color codes are important ? what if we use three phase cables without color code what will…

A: Why cable color codes are important and what if we use three phase cables without color code what…

Q: 2. A 25 cycle current is 15+j0 amp flows in an impedance having a resistance of 17.32 ohms and…

A: 2. Given data, Frequency, f=25 Hz Current, I=15+j0 A Resistance, R=17.32 A Inductive reactance,…

Q: Find the average voltage from 45⁰ to 180⁰ @ Em = 100 Volts? b) what is the average current if this…

A:

Q: The figure shows a 3-phase balanced negative sequence electrical system. Vcn = 200 /0° Vrms. Vbn = a…

A: Given

Q: A wattmeter with a current coil connected to phase A, and the voltage between phase A and C gives a…

A: Since, the value of the current for each phase is different that means the system represents the…

Q: Complex power S in (VA)                                         S=______________ Power P in Watts…

A:

Q: What is the Voltage per Phase? O 4340 Volts O 4430 Volts O 4530 Volts O 4360 Volts

A:

Q: Ten 100W lamps are connected. What circuit breaker is required if these are connected to a single…

A:

Q: 3. A 60 cycles current 2.8+j 0 flows in a series circuit having a resistance of 40 ohms, an…

A:

Q: TASK 3-Y-Y Three phase system The circuit in Figure 1 is a balanced three phase system which has the…

A: Note: Only active power will be available in purely R Load Only Reactive power will be available in…

Q: What is the phase difference between the following sets of the voltages currents And draw on the…

A: A)v=10 sin ωt+30°i=5 sin ωt+70°v=102∠30° , i=52∠70° Phase difference is=70°-30°=40°

Q: Three Inductive loads each of resistance R = 28 ohms and inductance L = 0.03 H are connected in star…

A:

Q: A 30 kVA, 2400/120V., 50Hz transformer has a high voltage winding resistance of 0.1Ω and a leakage…

A:

Q: A three-phase, 33 kV oil circuit breaker is rated 1200 A, 2000 MVA, 3s. The symmetrical breaking…

A: Given data:Required information:symmetrical breaking current =?

Q: Three identical capacitors of 25 micro farad are connected In staf acrUss 400 VUILS, 50HZ, 3-phase…

A: Here, we have three identical capacitors connected in star connection with a supply voltage of 400…

Q: The three-phase power line given in the figure is fed from both ends. The rated voltage is 380 V.…

A: The above question is based on the DC distribution system.Conductivity = 56 mho/mm = 56  mho/mHence,…

Q: the total power dissipated by three 702 resistors when connected a) in star and b) in delta to a…

A:

Q: Question No.23 The active power in a delta connected system of 440V with a balanced load of…

A:

Q: ethod. The reading on wattmeter A is 5,000 W and on wattmeter B is- 1,000 W (a) What is the power…

A:

Q: In a series circuit, a variable resistor and a 66.2 microfarad capacitor is supplied by a 120 volt,…

A: The solution is given below

Q: 11.In a certain s constant (2T) are the values

A:

Q: 2. A resi'sAno load of io n bs conneeded through. thyetsoor half- voano chreuit to 230v, sO M3. 1-9…

A:

Q: nd current of a three – phase load are as follows: Voltage: 3.6 kV, 8 degrees Current: 37 A, 45…

A: We are given voltage and current of a three-phase load as follows:V=3.6 kV, 8 degrees,Current = 37…

Q: Three unequal single phase loads so connected across the lines of a blanced 3 phase, 230 volts…

A: The phase voltage is equal to line voltage in a delta connection. The detailed solution is provided…

Q: Determine the circuit rating for the central air conditioner (5 ton) on a 120/240 V circuit

A: It is asked to determine the circuit rating for a 5 ton central air conditioner that is used on a…

Q: A three – phase load with 1.8 1.7 MVA and 0.92 0.85 leading power factor is connected to a 13.47 kV…

A:

Q: TASK 3-Y-Y Three phase system The circuit in Figure 1 is a balanced three phase system which has the…

A: Note: When source or load is connected in star connection, Phase current will be equal to line…

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.