The reading of a dynamometer-type wattmeter with pressure coil phase angle of 2°is 700 watts, when it is used to measure power of a single-phase inductive load supplied by 240 V single-phase a.c. source. When the wattmeter is replaced by a second wattmeter with a phase angle of 1° for the pressure coil circuit, a reading of 620 watts is obtained Calculate the actual power and current taken by the load, assuming all errors of the wattmeter, except those due to pressure coil inductance, are neglected.

The reading of a dynamometer-type wattmeter with pressure coil phase angle of 2°is 700 watts, when it is used to measure power of a single-phase inductive load supplied by 240 V single-phase a.c. source. When the wattmeter is replaced by a second wattmeter with a phase angle of 1° for the pressure coil circuit, a reading of 620 watts is obtained Calculate the actual power and current taken by the load, assuming all errors of the wattmeter, except those due to pressure coil inductance, are neglected.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

I:56)
A 4 pole, 3 phase, star-connected alternator has 24 slots with 12 conductors per slot and the flux per pole is 0.1 Wb. Calculate the line emf generated when the alternator is driven at 1500 rpm. All phase conductors are connected in series. Assume sinusoidal emf. (Ans = 1785 V)
Question 3/6 Determine the terminal voltage of a 4-pole, 3-phase alternator that is running at 50 hz. The alternator is constructed to have 24 stator slots and 6 conductors per slot in which 63mWb flux per pole is sinusoidally distributed. O 511.6 V O 532.1 V 528.2 V 579.44 V
3.The voltage generated across one inductor of an alternator is 8.11V. There are 120 slots and 4 turns in every coil. The conductors are all in series and connected in double layer lap windings distributed sinusoidally in several slots. The coil pitch is 10 slots, frequency is 60 Hz and synchronous speed is 720 rpm. Calculate the line-to-line generated voltage if the alternator windings are connected wye. a. 2400Vb. 4160Vc. 4800Vd. 856V
2. A cisuuit condirest of rescistance Rohm and an inductanceL henmy connected to a generator of the urrent in the ciocuit Ecoclwr ta) votrage. Fuind
6
A 5 kVA, 208 V, three-phase AC is connected in wye. Determine: the voltage of each coil of the phase windings. the coil current at full load. the line voltage and current values at full load if the phase windings of the alternator are reconnected in delta
Q) referring to Frgure below. cCircuit) a Vx t ly 10< -10°A (4) - Jlon o.) Find Curmnt Iy and Voltage Vx b) if the terminel a-b is short -Cir cuited, Find the new Current Iy Value.
What is the KW rating of a three phase 975 KVA generator at A) unity power factor B) 80% power factor C) 50% power factor
1. Convert the following decimal numerals to their binary, octal and hexadecimal equivalents (in case of infinite extension, compute the first 10 digits after dot): a. 55438, b. 237170, c. 586.609375 d. 22.016845703125 e. 416.712 2. Convert (416.715); to its decimal, binary, and hexadecimal equivalent 3. Find appropriate numeral system base, for which given equation is correct: a. 12,1 = 302/20 b. 41/3 = 13 c. 23+44+14+32 = 223 4. Find 8-bit l's complement numerals representing the following decimal numerals: a. 89 b. 135 c. 225 d. -37 e. -78 f. -128 g. -230 5. Repeat task 4, this time searching for 2's complement numerals 6. Compute: a. 11100 + 10001 b. 11100 + 00100 c. 01100 - 10011 assuming (one-by-one): signed-magnitude, l's complement, 2's complement representation
a) A sinewave is having a frequency of 60 Hz and instantaneous voltage of 100 Volts at 1.5 milli seconds. Find: i) The maximum value of sinusoidal voltage waveform ii) The value of voltage at 2.1 milli seconds. b) An alternating voltage is given by v=300 sin(120TTT +0.25) volts. Find: (i) Peak Value of Voltage (ii) r.m.s Value of voltage (iii) Phase angle in degrees with respect to 300sin(120Ttt). (iv) The instantaneous value of voltage when t=0 (v) Draw the sine wave of 300sin(120tt).
please write your Introduction about this topic , and answer please in print font do not write in hand writing ? beceuse I want to copy it ?