The ramp of a ship has weight W and center of gravity at G. Determine the cable force in CD needed to just start lifting theramp, (i.e., so the reaction at B becomes zero). Also, determine the horizontal and vertical components of force at the hinge (pin) at A.

Q: The 50-lb rectangular access door is held in the 90° open position by the single prop CD. Determine…

A: Given the weight of door and the position of door.  Required: F, A and B

Q: Determine the force developed in member GF of the bridge truss and state if these members are in…

A:

Q: Problem Statement Based on Problem 5-87 from the textbook. Both pulleys are fixed to the shaft and…

A:

Q: A rear suspension system for a front wheel-drive vehicle is shown here. Spring EF is offset behind…

A: According to the given data Reaction at wheel;m and road is 4200 N We need to find Determine the…

Q: has a mass of 75 kg. 6-90 The plate shown in Fig. The brackets at supports A and B exert only force…

A: Write the position vector of the points A, B, C and D.

Q: Determine the tensions in the cable, normal force in the smooth surfaces and the angle of…

A: Given Data: The weight W1 = 300 N. The weight W2 = 500 N. The free-body diagram of the blocks can…

Q: The cable supports the three concentrated loads shown below. Determine the vertical positions yB and…

A: Fig: FBD  ∑ME=0 4Ax+59Ay=400*47+410*27*160*12 4Ax+59Ay=31790                    1 Fig:FBD ∑MC=0…

Q: m The hoist supports an engine Determine magnitude of the force created by the engine mass

A: tanθ1=a+ba-btanθ1=2.2+1.12.2-1.1θ1=71.56o∑Fv=0RA+RB-mg=0RA+RB=mgRA+RB=175×9.81RA+RB=1716.75 N ,…

Q: Q4A: Calculate the forces in members AG,AB, CG, GF and CF for the truss shown. 2 kN C 2 m D 4 kN 2 m…

A: To calculate the forces in the member AG, AB, CG, GF, CF

Q: 7.5' |A 6.8' 0.6' B 2.4' 3.6' OFF HIO

A:

Q: Q5. Determine the member forces in each member of the the truss and state if they are in tension or…

A:

Q: Consider the following system in static equilibrium. Force vector Facts at a distance" from the pin…

A: (a) Draw the free-body diagram of bar.

Q: 4/2 Determine the force in each member of the loaded truss. Discuss the effects of varying the angle…

A:

Q: For the curved beam, determine the horizontal and vertical components of force at pin A and vertical…

A:

Q: The ramp of a ship has a weight of 250 lb and a center of gravity at G. Determine the cable force in…

A: Given: W = 250 lb

Q: Problem 4: The mass of the diver is 75 kg and the mass of the diving board is 45 kg. Draw the free…

A:

Q: The ramp of a ship has a weight of F Ib acts in the center of gravity at G. The ramp is supported by…

A:

Q: SITUATION. The suspended load exerts a force F-800lbs at A and bar OA weighs 300 lb. Assume that the…

A:

Slope and Deflection

The slope in a deflected beam is described as an angle in radians made by the tangent of the section with the original axis of the beam. The deflection at any point on the axis of the beam is defined as the lateral displacement of the point before and after loading.