The pump shown on the figure below has characteristic curves shown in the graph. Estimate the flow rate and, a) Calculate the pump power requirement b) Calculate the pressure at the pump inlet & outlet c) Sketch the EGL & HGL

Q: A Venturimeter is is placed at 30° to the horizontal (sloping upwards in the direction of flow) to a…

A: Note: As per policy, we can solve the first question only from multiple questions. Please resubmit…

Q: No. of plunger = 6, Plunger Diameter = 0.04 m, Stroke Length = 0.048 m and Rpm of Crank Shaft = 72.5…

A: Reciprocating pumps are positive displacement pumps. They suck water during forwarding stroke and…

Q: Figure below shows the performance curve family of Model 5009 Centrifugal pumps of Taco Pump Inc.,…

A:

Q: Hydraulic pump calculations Pressure = 600 PSI Displacement (D) = 0.4in3/rev 1150 RPM Total…

A: The given data in the question is: Pressure = 600 PSI Displacement (D) = 0.4 in3/rev Speed = 1150…

Q: 1. Find the power input required by the pump if pump efficiency is 75%. P 2 60°F Za - 50' (15.24 m)…

A:

Q: If the velocity of water is 8 m/s and the pressure is 140 kPa on the discharge side of a pump. a.…

A:

Q: Show in Figure 1 is the water flow system. The velocity head difference is = 2.0m. Volume flow rate…

A: Given data as per the question velocity head =2 m volume flow rate =0.5 m3/s h1 =1 m h2 =2 m hA = 3…

Q: Q No. 5: The diameter of side of a pump is 6 inches and that of the intake pipe is 8 inches. The…

A: According to the given information we have a diameter of the side pump is  D2  6inches =0.5 ft…

Q: a) Find the cross-sectional area of the incoming jet (in cm^2)   b) Find the horizontal force on…

A: U1=1.9 m/sA1=?U2=0.9 m/sA2=15cm2θ2=25oU3=0.8 m/sA3=10 cm2θ3=30oρ=1000 kg/m3

Q: B/ Find the flow rate in units of L/s that an axial piston pump delivers at 1000 rpm. The pump has…

A:

Q: 2. Draw HGL&EGL. Tank 1 Tank 2 Tank 3

A: For the solution refer below images.

Q: Analyze to select the type of the turbine when its diameter is 600 mm, rotational speed is 600 rpm…

A: Given: The diameter of wheel, D = 600 mm The rotational speed, N = 600 rpm The head of water, H =…

Q: A venturimeter is in an installation of 100 mm diameter pipe carrying water. The maximum range…

A: The diameter of pipe carrying water is D=100 mm=100 mm×m1000 mm=0.1 m. The maximum deflection…

Applied Fluid Mechanics

A fluid is a substance that is continuously deformed by the application of shear stress. The rate of deformation of a fluid depends on its viscosity. The fluid tries to flow when it interacts with some other system.