The profile of a soil consists of a soil layer 3.8 meters below the ground surface. The weight of the soil is 19.82 KN/m³. The water table is located 1.5 below the ground surface. The angle of friction of the soil 24° and a cohesion of 29 KPa. The saturated unit weight of soil below the water table is 18.51 KN/m³. Compute the effective stress in KPa at a depth of 3.8 meters below the ground surface.

Q: What is the measurement benchmark

A: The given questions asks about the measurement of benchmark.

Q: I need this answer handwritten mention question number also and please on white page I'll UPVOTE for…

A: Solution: The given problem is symetrical section with symmetrical loading: Hence it is enough to…

Q: ACTIVITY 6: LINE TYPES ft. a Simple Object Dimension line (Thin) 8 cm Extension line 5 mm THK Metal…

A: It comes under Engineering Drawing, also known as Engineering Graphics.  For Mechanical Engineering,…

Q: In the MIPS instruction "jr $1", what information does register $1 contain?     the address of the…

A:

Q: What is the most common scale used for temperature

A: The Celsius and fahrenheit scale is used most commonly used.. Kelvin scale is primarily used in…

Q: This is incorrect, please redo it, I have attached what the correct answers are supposed to be S

A: For a given soil profile, there is an upward seepage occurring. The velocity of the upward flow, v =…

Q: Convert 24 inches to feet.

A:

Q: What is the area of 6 #8 bars in inches^2? Give an answer to two decimal places.

A:

Q: Break the shaded area into the five different areas shown. Find the area and the x- and…

A: Determine  a. Break the shades area into the five different area and find area, x and y coordinates…

Q: A clockwise couple M = 4.5 N m is resisted by the shaft of the electric motor. (Figure 1) Part A…

A: Given: The moment M is 4.5 N.m. Consider the figure,

Q: Convert 1600 mils into equivalent value in grads O 90 degrees O 180 degrees O 270 degrees

A: To convert mils to degree

Q: What are Line of Balance Charts?

A: A line of balance chart is a graphical report of the schedule of projects that uses progression…

Q: H MM 0 10 20 30 40 50 60 70 80 90 100 DIMENSION THE PART USING METRIC DIMENSIONS. USE DIVIDERS OR…

A: The front view and top view of an object is shown in the above figures. Also scale of dimensions…

Q: Please write the answer l.

A: your question is incomplete buddy. please explain the question again. i definately want to help you…

Q: Define a logic loop.

A: The loop means a continuous order of formations which can repeat the work until a certain…

Q: WHICH ACI CODES DID YOU USE?

A: A building layout is given, we need to find out which ACI code is used in solving the problem

Unit Conversion

Standard units are also called SI units. SI units are used for measuring a physical quantity satisfying certain conditions. There are two types of units: fundamental units and derived units. Fundamental units are physical quantities that are independent, that is, they do not depend on other quantities like mass, length, or time. There are plenty of quantities in our lives which need to be measured and compared. Measuring is the comparison of a particular physical quantity with its reference value. A unit is a measure of a fixed physical quantity. A physical quantity is the product of a unit and the numerical value we need to compare with.