The power input to 100 hp, 480 V, 88% efficiency and 75 % power factor 3 phase motor at full load is measured by a two watt meter connected at lines A and C. What are the readings in kW?

Q: 4.A generating station has the following daily load cycle : Time (Hours) 0-6 6-10 10-12 12-16 Load…

A: In the generating system,  Daily load curve data are given Find the maximum demand Energy per day…

Q: An AC motor draws 5A from each line and runs with a line voltage of 460V. The motor is 90%…

A: Note: We are authorized to answer three subparts at a time, since you have not mentioned which part…

Q: ion generator depends upon: nase a) Slip E)Both b) rotor constants d) Neither a nor b a and b

A: The power factor of a three phase induction motor depends on slip and rotor constants.

Q: the generated e.m.f.

A:

Q: The shaft of a three-phase synchronous generator is rotating at 1800 RPM synchronous speed. This…

A: In this question , we will find total loss and torque induced in generator....

Q: Find the turns ratio of three single-phase transformers connected to form a three-phase system with…

A:

Q: A single-phase synchronous generator has a rated output of 500 kVA at a terminal voltage of 3300 V.…

A:

Q: The shaft of a three-phase synchronous generator is rotating at 1500 RPM synchronous speed. This…

A: Given: A 3-phase synchronous generator having Ns=1500 rpmP0=16.5 kWcosϕ=0.8 lagη=88% The copper…

Q: A generating station has the following daily load cycle :Time (Hours) 0-66-10 10-12 12–16 16-20…

A: In this question we will solve daily load curve .

Q: Instantaneous power output of a single phase 60 Hz generator will not be constant under following…

A: Instantaneous Power: Instantaneous power is defined as the electric power available at any given…

Q: A three-phase star-connected, 50-Hz generator has 48 coils per phase and a flux per pole of 0.1 Wb.…

A: Note: Since nothing is specified, so we will consider full pitch coil with pitch factor kc=1. One…

Q: 3. A 3-0 star-connected alternator is rated at 1600 kVA, 13,500 V. The armature effecti resistance…

A: In this question we will find voltage regulation of alternator with given power factor.... Note :-…

Q: Load duration curve Hours 0 500 2000 4500 6000 8760 Mw 50 Load 50 35 30 20 |15 there are two (2) -40…

A: Rating of each generator = 40 MW Energy = power X time Plant load factor = Actual energy generated…

Q: A load of 500 kW has a power factor of 0.6 lagging. Combined power factor is to be 0.9 using over…

A: We got an 500 KW load with, Load power (P1) = 500 KW Load power factor (Cos ϕ1) = 0.6  Synchronous…

Q: L-56.25 A I= P/43 VL = P/43 = 79.23 L-7923 A N at 0.71 lagging power factor. What is the ine cu *…

A:

Q: Three synchronous generator are connected in parallel to a an infinite s. G1 only provides active…

A:

Q: to

A:

Q: If it is desired to bring alternating current out of a generator, what kind of a "take-off" system…

A: If the alternating current is required from the generator a copper or brass rings are connected at…

Q: A 220 V three phase motor takes 21,437 W at 0.71 lagging power factor. What is the line curent? I=…

A: Given data, Power P=21437 W. Supply voltage V = 220 V Power factor cosϕ=0.71

Q: Single-phase motors are more efficient than three-phase motors for the same rate сарacity. Select…

A: The efficiency of single phase motor is low, whereas the efficiency of three phase induction motors…

Q: A 51 kVA load operates at 0.72 lagging power factor when connected to a 230 V, 60Hz AC source. The…

A: Steps to analyze the power factor improvement  Find the actual Active and reactive power at given…

Q: what is the kilowatt rating of a three-phase 975-KVA generator at. a.  unity power factor ? b. 80…

A:

Q: What are the benefits and drawbacks of SCR and IGBT? Which is the most popular, and why?

A:

Q: 12- Sketch the phasor diagrams of the following cases: i) Synchronous generator supplies both real…

A: GENERATOR/ALTERNATOR/SYNCHRONOUS GENERATOR: An alternator/Synchronous generator is a type of…

Q: The shaft of a three-phase synchronous generator is rotating at 1500 RPM synchronous speed. This…

A: Solve as below

Q: The actual impedance of a load is 30 OHM. The per-unit impedance of the load is 0.5 pu when Base…

A: In this answer let us try to find the base power used in order to get the given per unit impedance…

Q: The power input measurement to a synchronous motor is done using the two-wattmeter method. Each of…

A:

Q: (2-8) A zener diode has a de power dissipation of Iw and a zener voltage rating of 27v. What is the…

A:

Q: What is the working principle of a single phase motor

A:

Q: A 220 V three phase motor takes 21,437 W at 0.71 lagging power factor. What is the ine curent?…

A: For 3 phase,P3ϕ=3 VL IL  cosϕ IL =P3ϕ3 VL cosϕ For 1 phase,P1ϕ= VL IL  cosϕ IL =P1ϕ VL cosϕ

Q: The shaft of a three-phase synchronous generator is rotating at 3000 RPM synchronous speed. This…

A: In this question , we will find efficiency of generator.....

Q: what is the kVA rating of the synchronous motor

A: Three Phase Synchronous machine- This Synchronous machine comprises of rotor and stator as it basic…

Q: A three-phase synchronous generator is rotating at 800 RPM synchronous speed. The output power of…

A:

Q: 7. Two 440V, 60Hz, 6 pole, 30 AC generators are running in parallel. The first supplies the busbars…

A: It refers to the connection of multiple generators in a way to supply a common load. This…

Q: The shaft of a three-phase synchronous generator is rotating at 3000 RPM synchronous speed. This…

A: Principle of Machine: In any electrical machine either it's a DC machine or AC machine, the EMF in…

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.