The plate has a weight of W with center of gravity G. Determine the distance, d, along line GH where the vertical force P = 0.75W will cause the tension in cable CD to be zero. Ans. d 0.55L

Q: Use a triangle of the forces to determine the forces in struts AB and AC so that system is in…

A: Consider the diagram shown below for the forces in the members.

Q: P1-1. Draw a free-body diagram of the ring at A and identify each force. 30° 200 N 500 N (c)

A: To draw: The free body diagram at ring A and identify each forces. FBD: The free body diagram at A.…

Q: The gusset plate is subjected to the forces of three members s shown in. The forces are concurrent…

A: To find The magnitude of the tension force in member C.  The angle  Given The force on point O due…

Q: The guy wires AB and AC are attached to the top of the transmission tower. The tension in cable AB…

A:

Q: D FDA= 3.5 kN 9 m FDB= 2.5 kN FDc= 3.0 kN B 4.5 m 3 m 3 m 3 m A 30°

A: Write the coordinates of point D.   0, 0, 9   Write the coordinates of point A.   3sin30°, 3cos30°,…

Q: he uniform plank ABC weighs 40 kg. It is supported by a pin at A and a cable that runs around the…

A:

Q: air-fuel ratio for this combustion process.

A: Determine the air-fuel ratio for this combustion

Q: Consider the frame as shown. Determine: a) The forces acting on member AB at A and B. b) The forces…

A: According to the details provided in the question, we need to calculate forces at points A , B and…

Q: The three cables are used to support the 800-N lamp. Determine the magnitude of the force in cable…

A: given:

Q: Q2) If cable CB is subjected to a tension that is twice that of cable CA, determine the angle u for…

A: Mass of cylinder = 10 kg Tension in CB = 2 x Tension in CA

Q: Determine the magnitude of the reactions at A and C (resultant). 2m 1.8 m 3m O 15 KN/m

A: The free body diagram of the frame members along with reations at pins A,B and Cand their direction…

Q: unknown magnitude, IAB. i.e., coefficient a in the force vector TAB = TAB(a1 i + azj +az k). (sign…

A:

Q: The cable is loaded by a(n) Q = 73.4-lb vertical force at C and a horizontal force P at B. If x = 3…

A:

Q: Determine the angle a detween forces F, and F2. 2 m -3 m 3m - 50 kN I m F =30 kN y

A: The given system of forces is – Writing the coordinates of the system of the forces,

Q: The rectangular plate of sides 560 mm x 1590 mm is supported by hinges along its side BC and by the…

A:

Q: The guy wires AB and AC are attached to the top of the transmission tower. The tension in cable AB…

A: Given: The tension in cable AB, TAB = 9.6 kN The length, a = 47 m The length, b = 54 m The length, c…

Q: Use a triangle of the forces to determine the forces in struts AB and AC so that system is in…

A: Write the given values with suitable variables. θ=30°ϕ=45°

Q: Find the tensions in the ropes if the person has a weight of W = 170 N, the length of the plank…

A: Assume the height of person is 1.7 m. Draw the free-body diagram of the system.

Q: Point D is held in equilibrium by the cables as shown. If the force of F is 305 lb, then what is the…

A: Point D is held in equilibrium by the cables as shown. If the force of F is 305 lb.To Find-The…

Q: The oven door is spring loaded at C and pinned at A. Determine the magnitude of the normal force at…

A:

Q: 3. The unstretched length of an elastic cord is made to run vertically from the ceiling down to the…

A: Given data: The slope of an inclined cord, s = 4/5. Let T be the tension in the cord and F is a…

Q: If the tension force in strut AC is 12 kN, determine the forces in struts AB and AD, and the weight…

A: Given data Force in AC = 12 kN Determine the force in other two strut and weight of block.

Q: The guy wires AB and AC are attached to the top of the transmission tower. The tension in cable AB…

A:

Q: The guy wires AB and AC are attached to the top of the transmission tower. The tension in cable AB…

A:

Q: Y pies FD Fs D X 0,6 m FA W

A:

Q: Determine the tension in each of the three ropes supporting the crate. 2 ft 4 ft 4 ft В y 1.6 ft 4…

A:

Q: Determine the resultant of the three cable tensions that act on the horizontal boom if T1 = 900 lb,…

A: Consider the triangle AOB. The tension T2 is along the hypotenuse AB.We need to find the component…

Q: Three cables are used to tie the balloon shown in the Figure. Determine the magnitude of the…

A: To find: The vertical force exerted by the balloon. Given: The tension in the cable AD is TAD=1.641…

Q: 2. The 30 cm handle is connected rigidly to the 5cm bar at a right angle. Determine the force…

A: The force applied to the handle is, P=100 N Length of the handle is, L=30 cm

Q: The rectangular plate of sides 530 mm x 1240 mm is supported by hinges along its side BC and by the…

A:

Q: The 141 lb uniform tank is suspended by means of a 6.3-ft-long cable, which is attached to the sides…

A:

Q: In the equilibrium position shown, the resultant of the three forces acting on the bell crank passes…

A:

Q: Situation 5. Determine the forces in cables AC and AB needed to hold the 20-kg ball D in…

A: GivenF=300Nm=20kgd=1m

Q: 2 KN/m 2 KN/m URN A 30 3.0m 3m 2.0m 2.0 m 4,0 m

A: There are three different types of loads are there on this beam which are Uniformly varying,…

Q: H. 0.5 ft Determine Ax, Ay and Tension at C 0-30 108 lb

A:

Q: find the force in each tinder (ring) and determine if it is in tension or compression using the node…

A:

Q: If the tension developed in each of the three cables, AB, CD, and EF, is the same, find the location…

A:

Q: 5. The guy cables AB and AC are attached to the top of the transmission tower. The tension in cable…

A: Since you have posted multiple questions, we will provide the solution only to the first question as…

Power Transmission Elements

It is defined as the energy transfer from one location to another location. The energy will start moving from the energy generation source to the energy applied position to obtain the work output. From this method, a large amount of electric energy moves from the power station to various electrical substations.