The gusset plate is subjected to the forces of three members s shown in. The forces are concurrent at point O. Take 9 kN A 22.0 B C

Q: Determine the reactions at support A of the rigid body shown in the image. Also, indicate on your…

A:

Q: Determine the tension force in member C and its angle e for equilibrium. The forces are concurrent…

A: Concurrent forces are those that overlap in a single place.  If the forces are contemporaneous, we…

Q: Two forces F1 150 N and F2 50 N to hold the weight of 200 N. Check and determine if the body is in…

A: Equilibrium is a state of a body at which there is no disturbance in a system neither inside nor…

Q: The springs in are shown in the equilibrium position. 3m 3 m KAC = 20 N/m KAB = 30 N/m wwwww KAD-40…

A:

Q: The vertical mast supports the 6.2-kN force F and is constrained by the two fixed cables BC and BD…

A: Given:The force is .The distances are .The system is shown below.To find:The tension in the cable .

Q: The vertical mast supports the 4.3-kN force F and is constrained by the two fixed cables BC and BD…

A: Givena=5.8mb=3.6mc=2.1mh=5.2m

Q: Each cord can sustain a maximum tension of 200 N. Detcrmine the largest weight of the sack that can…

A: Draw the FBD for the lowermost segment.

Q: 1.If cable CB is subjected to a tension that is twice that of cable CA, determine the angle 0 for…

A:

Q: The forces and all lengths are given in the image. If the pile is in equilibrium, find out all…

A: Given figure  To determine all support reaction components at the fixed support O.

Q: The sign has a mass of 100 kg with a center of mass at G. Determine the components of the reaction…

A: Write the point vectors for each point. A=0, 0, -0.5B=0, 2, 0C=1, 0, 2D=-2, 0, 1 Write the vectors…

Q: Q3. The lamp has a weight of ( 40 N) and is supported by the six cords connected together as shown.…

A: Given Data W=40 N

Q: Determine the force in cables AB, AC, CD, CE, and CF needed to support the 500-lb crate. Complete…

A: The weight of crate is

Q: Member AB is supported by BC and at A by a single journal bearing with a square shaft. Determine the…

A: Free body diagram:Position vector:System A will move up and down, therefore there won't be any…

Q: Two forces F1 150 N and F2 50 N to hold the weight of 200 N. Check and determine if the body is in…

A: Given data, Force F1 = 150 N and, F2 = 50 N Force F1 in vector form, F→1= F1-sin45i^+cos45j^ F→1 =…

Q: Consider the following system in static equilibrium. Force vector Facts at a distance" from the pin…

A: (a) Draw the free-body diagram of bar.

Q: The mass center G of the 1220-kg rear-engine car is located as shown in the figure. Determine the…

A:

Q: Determine the tension developed in wire CD required for equilibrium of the 37 lb cylinder E and the…

A: Given  Weight, WE = 37 lb              WF = 46 lb Find   Tension in CD, TCD