The pilot of a crippled jet was able to control his plane by throttling the two engines. If the plane has a weight of 17 000 lb and a radius of gyration of kg = 4.7 ft about the mass center G, determine the angular velocity of the plane and the velocity of its mass center G in t = 5 s if the thrust in each engine is altered to T¡ = 5000 lb and T, = 800 lb as shown. Originally the plane is flying straight at 1200 ft/s. Neglect the effects of drag and the loss of fuel.

The pilot of a crippled jet was able to control his plane by throttling the two engines. If the plane has a weight of 17 000 lb and a radius of gyration of kg = 4.7 ft about the mass center G, determine the angular velocity of the plane and the velocity of its mass center G in t = 5 s if the thrust in each engine is altered to T¡ = 5000 lb and T, = 800 lb as shown. Originally the plane is flying straight at 1200 ft/s. Neglect the effects of drag and the loss of fuel.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A man, 65 kg, descends to the ground with the help of a parachute, 18 kg. The parachute is hemispherical in shape, 2m diameter. Density of air can be taken as 0.00125 g/cm³ and its kinematic viscosity as 0.15 stoke. What is the terminal velocity of the parachute? (Take C₁ = 1.5 and g = 1000 cm/sec²) A B с D 16.6 m/sec 15.8 m/sec 15.0 m/sec 14.1 m/sec
A closed tank 2 m deep, 1.8 m wide and 3.5 long has been filled with gasoline of S= 0.8 upto a depth of 1.6 m. Calculate the acceleration which may be imparted to the tank in the direction of its length so that bottom front end of the tank is just exposed. Also calculate the net horizontal force acting on the tank sides sides and show that this is equal to force necessary to accelerate the liquid mass.
Calculate the value of the reaction at support B of the beam shown below. Answer is in one decimal place, units in kN. No need to input the units. Just input the numerical value of your answer. USE THREE MOMENT EQUATION. 100 kN 30 kN/m A B 2m 3m 3m 2m 5m, El 5m, 1.5EI 150mm 150mm E = 100 GPa 150mm
A commercial airliner with four jet engines, each producing 72 kN of forward thrust, is in a steady, level cruise when engine number 3 suddenly fails. Determine the distance d (measured up or down on the figure) to the resultant of the three remaining engine thrust vectors. Treat this as a two-dimensional problem. The distance d is positive if above the center line of the airplane, negative if below.
28) A cannon ball is fired across a flat field at an angle of 52° with an initial speed of 36 m/s and an initial height of 10 m. i) Write a set of parametric equations for the motion of the cannon ball. ii) Determine how long the cannon ball was in the air. iii) Determine how far the cannon ball traveled in the air. iv) Determine when the cannon ball reached its maximum height. v) Determine the maximum height reached by the cannon ball. vi) Sketch the graph of the parametric equations. 140 120 100 20 40 60 NO 100 120 140 *
A 10,000-lb airplane is launched from a catapult. The spring of the catapult (ks = 150 lb/in) is initially compressed 10 ft and then released. During the launching, the airplane engine exerts a constant horizontal force of 2,000 lbs. Assuming the friction to be negligible, determine the takeoff speed of the airplane at the instant when the spring reaches its undeformed position. 15.47 ft/s 25.34 ft/s 34.64 ft/s 26.62 ft/s 64.34 ft/s 62.26 ft/s 21.16 ft/s 58.17 ft/s ||| wwwww k,= 150 lb/in. <
A horizontal pipe of cross section 8 cm2 has a constriction of cross section of 2 cm². Gasoline flows in the larger pipe with a speed of 10 cm/s. What is the speed in the constriction in cm/s? O 40 O 10 O 80 O 20
Fluid Mechanics (question 2)in the solution can you provide the conversion/s (if neccessary to the question) so I could understand how to solve it better
A commercial airliner with four jet engines, each producing 76 kN of forward thrust, is in a steady, level cruise when engine number 3 suddenly fails. Determine the distance d (measured up or down on the figure) to the resultant of the three remaining engine thrust vectors. Treat this as a two-dimensional problem. The distance dis positive if above the center line of the airplane, negative if below. 76 kN 7.7 m 3 12.9 m 12.9 m 76 kN 7.7 m 76 kN 1 Answer:d = i E
The speed of the pickup truck's engine is controlled by the Porter governor with 4 arms of equal length, and pivot on the axis of rotation. Each ball has a mass of 4 kg and the mass of the central load on the sleeve is 20 kg. The radius of rotation of the ball is 150 mm when the governor begins to lift, and 200 mm when the governor is at maximum speed. The initial angular speed of the engine's crank is 14 rad/s, and it has reached a maximum speed at an acceleration of 0.4 rad/s? after 5 seconds. 2.1. If the speed of the crank of an engine is equal to the speed of its governor, calculate the angle between the upper arm and axis of rotation (a) when the governor starts to lift and when it is at maximum speed. 2.2. Prove that the length of the governor's arms is equal.
If the jet on the dragster supplies a constant thrust of T = 17.8 kN, determine the power generated in kW by the jet at time 4.1. Neglect drag and rolling resistance, and the loss of fuel. The dragster has a mass of 1.49 Mg and starts from rest. T
Superman Vi