A commercial airliner with four jet engines, each producing 76 kN of forward thrust, is in a steady, level cruise when engine numb suddenly fails. Determine the distance d (measured up or down on the figure) to the resultant of the three remaining engine thrus vectors. Treat this as a two-dimensional problem. The distance d is positive if above the center line of the airplane, negative if bele 4 76 kN- 7.7 m 3 12.9 m 12.9 m 76 kN 2 7.7 m 76 kN Answer:d = i E

A commercial airliner with four jet engines, each producing 76 kN of forward thrust, is in a steady, level cruise when engine numb suddenly fails. Determine the distance d (measured up or down on the figure) to the resultant of the three remaining engine thrus vectors. Treat this as a two-dimensional problem. The distance d is positive if above the center line of the airplane, negative if bele 4 76 kN- 7.7 m 3 12.9 m 12.9 m 76 kN 2 7.7 m 76 kN Answer:d = i E

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A commercial airliner with four jet engines, each producing 72 kN of forward thrust, is in a steady, level cruise when engine number 3 suddenly fails. Determine the distance d (measured up or down on the figure) to the resultant of the three remaining engine thrust vectors. Treat this as a two-dimensional problem. The distance d is positive if above the center line of the airplane, negative if below.
PROBLEM NO. 3 Determine the downward acceleration ag of cylinder B if the vertical t4 where t is in displacement of cylinder A in meters is given by y = seconds. Also identify the number of degrees of freedom. A В
A disk with 10 cm radius rolls without slipping down a 30°- inclined plane. At the instant shown, the angular velocity of the disk is w = 5rad/s, CW and its angular acceleration is a = 2 rad/s², CW. Its rightmost end is attached to rod AB (angled 45°) with the length of 24.56 cm. The other end of the rod is attached to collar B that is confined to move along the vertical. (A) Determine the angular acceleration of the rod, (B) Determine the velocity of the rod, (C) Determine the acceleration of collar B at this instant. - 5 rad/ a=2 rad/² r-10 cm 30° 45°
1. Determine the velocity of the jet at A in m/s. 2. Determine the velocitv of the it at C in m/s 3. Determine the constant acceleration of the it in m/s4
Knowing that at the instant shown crank BC has a constant angular velocity of 45 rpm clockwise, determine the acceleration of Point A and Point D.
A 75 mm jet has a velocity of 35 m/s. It strikes a blade moving in the same direction at 20 m/s. The deflection angle of the blade is 150°. Neglecting frictions, calculate:A). The horizontal component of the force exerted by the water on the blade.B). The vertical component of the force exerted by water on the blade.
The tank of water in figure accelerates uniformly by freely rolling down a 30° incline. If the wheels are frictionless, what is the angle 0? 30
A vertical cylindrical tank 3 m in diameter has a circular orifice 10 cm in diameter on the vertical side at its bottom. The tank is filled with water such that the head over the orifice is 7 m. If Cᵥ = 0.98 and C꜀ = 0.61, *determine (a) the interval of time for the velocity of the jet issuing at the orifice to change from 10 m/s to 7 m/s. Assume that the velocity of approach is negligible. *what is the head when the velocity is (b) 10 m/s? Assume that the velocity of approach is negligible..... *what is the head when the velocity is (c) 7 m/s? Assume that the velocity of approach is negligible....
Solve
Fluid of mechanics
A body weighing 2225 N is being dragged along a rough horizontal plane by a force of P=445 N. If the coefficient of friction is 1/12 and the line of the pull makes an angle of 18° above the horizontal what are the velocities acquired from rest in the first 3.65m and in the first 5.50m?
A 97-ft³/s water jet is moving in the positive x-direction at 18 ft/s. The stream hits a stationary splitter, such that half of the flow is diverted upward at 45⁰° and the other half is directed downward, and both streams have a final average speed of 18 ft/s. Disregarding gravitational effects, determine the x- and z-components of the force required to hold the splitter in place against the water force. Take the density of water as 62.4 lbm/ft³. L₂ V ft³/s- The x-component of the force is The z-component of the force is 45⁰ 45⁰ 18 ft/s -Splitter lbf. lbf.