The perpendicular offset distance of point B on a simple curve is 175 ft on the tangent line from the PT. If the distance from the PT to point A is 740 ft. if the station of P.T. 25+01.21 a) Solve for the radius of the curve. b) Solve for the stationing of point B. c) Solve for the chord from PC to point B, when I = 50°

Q: I need help figuring out where to place the counterbored hole on the drawing as there is ro referce…

A: Positions of counterbored holes are indicated in the left view of the drawing with the dimensions…

Q: The angular velocity of AB is 8.00 rad/s lockwise in the position shown in the iagram at the right.…

A: Given,  wAB= 8 rad/s

Q: Draw the section view (locate the section line/cutting line along midpoint of dim 71 )

A:

Q: Convert the bracket into an isometric drawing mark the corner marked A as the lowest point of the…

A: Approach to solving the question: To solve the question, identify corner A as the lowest point and…

Q: 7. Point A on Link AB has a velocity of 75.0 in/s up the slot in the position shown. a) Calculate…

A: given; velocity when up the slot (VA)=75in/sAB=15inBC=10 inBD=12infor inclination vertical…

Q: Draw the three standard orthographic views for the following object.

A: Draw the three standard orthographic views for the following object.

Q: a) A simply supported beam has a symmetrical rectangular cross-section. If the second moment of area…

A: Given: The inertia of the rectangular section is, I=11.50×106 mm4. The depth of the rectangular…

Q: Calculate the Maximum X distance on the drawing below: 1.000 C 2.000 Ø.995-1.000 6.00 0.008MABC X…

A: Maximum distance of X on the drawing is to be calculated.... Remember that maximum distance of X is…

Q: 20 30 40. -30 100- Draw the three projections of the following figure 60

A:

Q: 64 61 64 51 114 3 38 64 822 R32

A: The Front View, Top View and Right hand side view is given below.

Q: I need help answering this.

A: 1)  Only one angular dimension is shown on this print  .i.e., 16002) Two  reference dimensions are…

Q: Homework Draw (i) the sectional view from the front and (ii) the view from the left of the sliding…

A:

Q: The cross section of a wooden beam is shown. a. Calculate the I b. Calculate the force in nails in…

A: The space between nails at A is 60 mm and at B is 25 mm Vertical shear force = 16 kN It is asked to…

Center of Gravity and Centroid

The term center of gravity indicates the position or location of a point about which the whole weight of a body or system is supposed to be concentrated, which means the whole weight of the body or system works through this point. It is closely related to mass distribution. For all positions of the body, the center of gravity would be a single point.